(1) The studies on the influence of rainfall on slope stability mainly focus on rainfall characteristics and the variation of strength parameters. Few studies pay attention to the micro structure changes of rock mass under long-term rainfall conditions, and the influence of failure mode. (2) Based on nuclear magnetic resonance (NMR) and electron microscopic imaging (Emmi) technology, the micro structure changes and macro deformation characteristics of the schist, under long-term immersion in different liquids are analyzed. (3) After soaking in the deionized water, the uniaxial compression strength of the intact specimen is slightly lower than that of the untreated specimens, but the test process in the elastic compression stage is considerably prolonged, and the failure modes show both shear and slip at the same time. While after soaking in acid solution, the fracture of rock samples with initial cracks can be obviously reduced and healed, which is consistent with the change of micro pore structure. The uniaxial strength and modulus of the intact samples are significantly lower, and only slip failure mode occurred. (4) It shows that water–rock interaction is an important factor influencing the stability of slope besides the external rainfall force, which affects the structural characteristics and mechanical properties of rock.

The drying-wetting cycles caused by operation of the Three Gorges Reservoir have considerable effect on the deterioration of reservoir bank rock mass, and the degradation of reservoir rock mass by the drying-wetting cycle is becoming obvious and serious along with the periodic operation. At present, the strength of the rock prediction research mainly focuses on the uniaxial strength, and few studies consider the drying-wetting effect and confining pressure. Therefore, in this paper, typical sandstone from a reservoir bank in the Three Gorges Reservoir area is taken as the research object, while the drying-wetting cycle test, wave velocity test and strength test are carried out for the research on the strength prediction of sandstone under the action of the drying-wetting cycle. The results show that the ultrasonic wave velocity Vp of the sandstone has an exponential function relation with the drying-wetting cycle number n, and the initial stage of drying-wetting cycles has the most significant influence on the wave velocity. Under different confining pressures, the compressive strength of sandstone decreases linearly with the increase of the drying-wetting cycle numbers, and the plastic deformation increases gradually. The damage variable of the sandstone has a power function relation with the increase of drying-wetting cycle numbers. A traditional strength prediction model based on P-wave velocity was established combined with the damage theory and Lemaitre strain equivalence hypothesis; in view of the defects of the traditional strength prediction model, a modified model considering both the drying-wetting cycle number and confining pressures was proposed, where the calculated results of the modified model are closer to the test strength value, and the prediction error is obviously decreased. This indicated that the modified model considering the drying-wetting cycle number and confining pressure is reasonable and feasible.

It is very important to accurately determine the depth of excavation damaged zone for underground engineering excavation and surrounding rock stability evaluation, and it can be measured by acoustic test, but there is no quantitative method for analysis of the results, and it relies heavily on the experience of engineers, which leads to the low reliability of the results and also limits the application of the acoustic method. According to substantial field test data and the feedback of surrounding rock support parameters, the boundary method is proposed to determine the depth of excavation damaged zone in surrounding rock based on the relation between the ultrasonic velocity of measured point and the background wave velocity of rock mass. When the method is applied to the columnar jointed rock mass of Baihetan and the deep‐buried hard rock of Jinping, the excavation damaged zone was well judged. The results in the Baihetan project show that the proposed method of determining excavation damage zone by the acoustic test can well demonstrate the anisotropy characteristics of the columnar jointed rock mass, and the damage evolution characteristics of jointed rock mass at the same position can also be obtained accurately. Moreover, the method also can accurately reveal the damage evolution process of the deep‐buried hard rock under the condition of high ground stress, which proved the applicability of this method in jointed or nonjointed rock masses.