In this paper we explore the application of low-loss multimode anti-resonant hollow-core fiber (MM-AR-HCF) in the delivery of nanosecond laser pulses at 1 µm wavelength. MM-AR-HCF with large core offers a rich content of low-loss higher-order modes which plays a key role in the efficient coupling and transmission of high-power laser of low beam quality. In the experiment, laser pulses of an average pulse energy of 21.8 mJ with 14.6 ns pulse width (corresponding a peak power of 1.49 MW) are transmitted through MM-AR-HCF of 9.8 m length without damage. 85% transmission efficiency is achieved where the incident laser beam suffers a low beam quality with M2x and M2y of 2.18 and 1.99 respectively. Laser-induced damage threshold (LIDT) of MM-AR-HCF was measured to be 22.6 mJ for 85% transmission efficiency, which is 7 times higher than that for a multimode silica optical fiber with a large core of 200 µm.
Traditional planar diffractive optical elements (DOEs) are challenged in imaging systems due to diffraction efficiency and chromatic dispersion. In this paper, we have designed a microfluidic diffractive optical element (MFDOE), which is processed by digital micromirror device (DMD) maskless lithography (DMDML) assisted femtosecond laser direct writing (FsLDW). MFDOE is a combination of photoresist-based multi-layer harmonic diffraction surface and liquid, realizing diffraction efficiency of more than 90% in the visible band. And it shows achromatic characteristics in the two bands of 469 nm (±20 nm) and 625 nm (±20 nm). These results show that MFDOE has good imaging performance.
Object-space model optimization (OSMO) has been proven to be a simple and high-accuracy approach for additive manufacturing of tomographic reconstructions compared with other approaches. In this paper, an improved OSMO algorithm is proposed in the context of OSMO. In addition to the two model optimization steps in each iteration of OSMO, another two steps are introduced: one step enhances the target regions’ in-part edges of the intermediate model, and the other step weakens the target regions’ out-of-part edges of the intermediate model to further improve the reconstruction accuracy of the target boundary. Accordingly, a new quality metric for volumetric printing, named ‘Edge Error’, is defined. Finally, reconstructions on diverse exemplary geometries show that all the quality metrics, such as VER, PW, IPDR, and Edge Error, of the new algorithm are significantly improved; thus, this improved OSMO approach achieves better performance in convergence and accuracy compared with OSMO.
27 February 2023 in Journal of Micromechanics and Microengineering
Diffractive optical elements (DOEs) with rotationally symmetric phase distribution are mainly produced by laser direct writing technique in a polar coordinate system, which has slow processing speed and limited fabrication area. In this paper, we propose a digital micro-mirror device maskless digital lithography technique based on stepwise rotary stitching. DOEs with rotationally symmetric phase distribution are fabricated by exposure of stitching units and rotation of rotary tables. Then, different stitching units are designed to compensate for the errors caused by the accuracy of the rotary table. Finally, the high quality DOEs are produced by the double-exposure method. When increasing the fabrication area, significantly improves the saw-tooth of the lithography pattern edge while reducing misalignment and overlap of stitching caused by residual errors. The diameter of the fabricated Fresnel zone plate was increased from 5.25 mm to 11.40 mm, and the fabrication area was 4.72 times larger than conventional lithography. The stitching error of 18.95 μm has been eliminated after optimization, and the pixelization has been smoothed. The diffraction results show that the method not only can produce large area and high-quality diffraction elements but also greatly reduce the processing cost.