The Adriatic Sea and its coastal region have experienced significant environmental changes in recent decades, aggravated by climate change. The most prominent effects of climate change (namely, an increase in sea surface and air temperature together with changes in the precipitation regime) could have an adverse effect on social and environmental processes. In this study, we analyzed the time series of sea surface temperature and air temperature measured at three meteorological stations in the Croatian part of the Adriatic Sea. To assess the trends and variations in the time series of sea surface and air temperature, different statistical methods were employed, i.e., linear and quadratic regressions, Mann–Kendall test, Rescaled Adjusted Partial Sums method, and autocorrelation. The results evidenced increasing trends in the mean annual sea surface temperature and air temperature; furthermore, sudden variations in values were observed in 1998 and 1992, respectively. Increasing trends in the mean monthly sea surface temperature and air temperature occurred in the warmer parts of the year (from March to August). The results of this study could provide a foundation for stakeholders, decision–makers, and other scientists for developing effective measures to mitigate the negative effects of climate change in the scattered environment of the Adriatic islands and coastal region.

In the Italian Southern Alps, the Lombardic and Venetian chains and related foreland are separated by the Lessini-Berici- Euganei foreland block, which is unaffected by the Neogene-Quaternary shortenings. However, the Veneto-Friuli alluvial plain to the east of this foreland block has been affected by a poly-phase evolution since the Mesozoic era and represents the foreland of three surrounding chains. The area was affected by several flexural cycles related to the diachronous build-up of the External Dinarides to the east (Late Cretaceous-Late Eocene), the Eastern Southern Alps to the north (Late Oligocene-Quaternary), and the Northern Apennines to the southwest (Middle Miocene-Quaternary). The last two chains are currently active, although at different rates. The western margin of the foreland is marked by the Schio-Vicenza fault, which divides the deformed foreland (Veneto-Friuli alluvial plain) from the undeformed foreland (Lessini and Berici Mountains and Euganei Hills). The aim of this work is to unravel the architecture and evolution of this boundary using 2D seismic sections and deep wells acquired by ENI for hydrocarbon exploration. Approximately 1,000 km of seismic lines were interpreted and 10 wells were used to calibrate the seismic interpretation. Seven seismic sections that are sub-orthogonal to the main faults were selected to obtain geological cross-sections through a depth conversion process. The collected data display a complex buried fault system (Schio-Vicenza fault system) that extends with a NW-SE trend from the foot of the Prealps to the Po Delta. In the cross sections, the movement of the fault shows a vertical component with down-throw of its eastern side (hanging wall block). Some faults display a Mesozoic extensional displacement in accordance with the Mesozoic basin and swell architecture of the area. In addition, the Pliocene throw increases from the southeast to the northwest. Therefore, the Schio-Vicenza fault system can be interpreted as an inherited Mesozoic structure that reactivated during the Neogene shortening of the area. In particular, this fault system appears to have been mainly active during the Pliocene-Quaternary flexural cycle that is related to the Northern Apennines subduction, which is when the fault system accommodated a scissor movement between the Veneto-Friuli foreland and the Lessini-Berici-Euganei block

The interest on low‐temperature geothermal resources is progressively increasing since their renewability and widespread availability. Despite their frequency, these resources and their development have been only partially investigated. This paper unravels the major physical processes driving a low‐temperature geothermal resource in NE Italy (Euganean Geothermal System) through conceptual and numerical modeling. Dense fracturing associated to regional fault zones and a relay ramp enhances regional to local flow of thermal waters. Their rapid upwelling in the Euganean Geothermal Field is favored by open extensional fractures deforming the relay ramp. The water (65–86 °C) is intensively exploited for balneotherapy, rendering it a profitable resource. Three‐dimensional coupled flow and heat transport numerical simulations based on this conceptual model are performed. Despite the presence of a uniform basal heat flow, a thermal anomaly corresponding to field observations develops in the modeling domain reproducing the relay ramp. Intensive fracturing extending across a wide area and a slightly anomalous heat flow favors a local increase in convection that drives the upwelling of deep‐seated hot waters. The simulations corroborate and refine the conceptual model, revealing that water of up to 115 °C is likely to be found in the unexplored part of the thermal field. This study furthers knowledge on fault‐controlled low‐temperature geothermal resources where the geological setting could enhance local convection without anomalous heat flows, creating temperatures favorable for energy production. Conceptual and numerical modeling based on solid geological and hydrogeological reconstructions can offer a support tool for further detailed explorations of these prominent resources.

The point dilution test is a single-well technique for estimating horizontal flow velocity in the aquifer surrounding a well. The test is conducted by introducing a tracer into a well section and monitoring its decreasing concentration over time. When using a salt tracer, the method is easy and inexpensive. Traditionally, the horizontal Darcy velocity is calculated as a function of the rate of dilution and is based on the simple assumption that the decreasing tracer concentration is proportional both to the apparent velocity into the test section and to the Darcy velocity in the aquifer. In this article, an alternative approach to analyse the results of point dilution tests is proposed and verified using data acquired at a test site in the middle Venetian plain, northeast Italy. In this approach, the one-dimensional equilibrium advection–dispersion equation is inverted using the CXTFIT model to estimate the apparent velocity inside the test section. Analysis of the field data obtained by the two approaches shows good agreement between the methods and suggests that it is possible to use the equilibrium advection–dispersion equation to estimate apparent velocity over a wide range of velocities.