We have studied theoretically magnetic resonance force microscopy with a high-frequency nanomechanical cantilever when the cantilever frequency matches the resonant frequency of a single electron spin. Our analysis shows that in this situation, there is a small probability that the cantilever will oscillate with a large frequency shift. This can open new experimental opportunities for increasing the sensitivity in the detection of a single electron spin or even a single nuclear spin by using a high-frequency cantilever.
We study the electron spin relaxation induced by a high frequency nanomechanical cantilever with an attached ferromagnetic particle in a situation when the spin Larmor frequency matches the cantilever frequency. We consider a situation when the spin–cantilever system is described by the Jaynes–Cummings model. We have obtained an analytical solution describing the spin relaxation caused by the spin–cantilever interaction. Based on these results, we suggest a “spin thermometer” that could measure the temperature of nanomechanical cantilevers.
We consider magnetic resonance force microscopy (MRFM) in the situation when the frequency of the electron spin resonance matches the fundamental frequency of the cantilever with a ferromagnetic particle attached to its tip. We suggest that in this situation, the quantum states of the oscillating cantilever may represent a qubit. We develop a scheme for manipulation with the qubit state and derive the expression describing the Rabi oscillations of the qubit.
We discuss the implementation of quantum logic in a system of strongly interacting particles. The implementation is qubitless since ``logical qubits'' don't correspond to any physical two-state subsystems. As an illustration, we present the results of simulations of the quantum controlled-NOT gate and Shor's algorithm for a chain of spin-1/2 particles with Heisenberg coupling. Our proposal extends the current theory of quantum information processing to include systems with permanent strong coupling between the two-state subsystems.
The quantum adder is an essential attribute of a quantum computer, just as classical adder is needed for operation of a digital computer. We model the quantum full adder as a realistic complex algorithm on a large number of qubits in an Ising-spin quantum computer. Our results are an important step toward effective modeling of the quantum modular adder which is needed for Shor's and other quantum algorithms. Our full adder has the following features: (i) The near-resonant transitions with small detunings are completely suppressed, which allows us to decrease errors by several orders of magnitude and to model a 1000-qubit full adder. (We add a 1000-bit number using 2001 spins.) (ii) We construct the full adder gates directly as sequences of radio-frequency pulses, rather than breaking them down into generalized logical gates, such as Control-Not and one qubit gates. This substantially reduces the number of pulses needed to implement the full adder. [The maximum number of pulses required to add one bit (F-gate) is 15]. (iii) Full adder is realized in a homogeneous spin chain. (iv) The phase error is minimized: the F-gates generate approximately the same phase for different states of the superposition. (v) Modeling of the full adder is performed using quantum maps instead of differential equations. This allows us to reduce the calculation time to a reasonable value.