This study focuses on modeling and analysis of the non‐isothermal, non‐adiabatic, dehydrogenation of cyclohexane in membrane catalytic reactors. The dehydrogenation reaction is endothermic with a low equilibrium conversion of 0.06 at a temperature of 473 K and pressure of 101 kPa. The membrane reactor removes hydrogen from the reaction mixture and results in increase of the reaction conversion. The analysis is made as a function of feed flow rate, feed temperature, feed composition, inert flow rate in the feed stream, flow rate of sweep gas, pressures of the tube side and shell side, permeability constant of hydrogen, and tube diameter. The analysis also includes a study of the co‐current and the counter‐current flow modes. The results show lower conversion for the counter‐current flow mode, because of the decrease in the driving force for permeation. A comparison of model predictions against previous literature studies shows good agreement.
Polybutylene/starch/nanoclay composite blends were prepared by melt extrusion technique. Maleic anhydride grafted polybutylene was used as a compatibilizer. The nanocomposites were characterized by X-ray diffraction, scanning electron microscopy, transmission electron microscopy, atomic force microscopy, rheological, and mechanical analysis. Addition of compatibilizer to the polybutylene/starch/nanoclay showed dispersion and nucleation related to the nanoclay in the polybutylene matrix. An increase in the mechanical properties like modulus and tensile strength at break and a decrease in the elongation at break were observed on the addition of compatibilizer to the matrix compared to that of uncompatibilized matrix. The biodegradability of the nanocomposites was studied using the landfill burial test. The blends subjected to the burial test were evaluated for their tensile properties. The results revealed that the tensile strength and elongation at break of the compatibilized nanocomposites decreased after 80 days of land burial test compared to the initial period.