Double-tee profiles are the most popular members in Europe and the USA for steel structures. However, more efficient cross-sections, such as circular hollow sections (CHSs), could be adopted, since they can provide higher aesthetic, economic and mechanical benefits, with the only drawback of more complex connections such as in the case of I-beams welded to the external surface of circular hollow profiles. Based on the ring model theory, developed by Togo, a rule to design the flexural resistance of such a connection has been included in the Eurocode 3 part 1.8, while no formulations are provided to predict the corresponding initial stiffness. The present work aims at filling this knowledge gap, adopting an approach based on experimental, numerical and analytical work. A monotonic and a cyclic test have been performed on two beam-to-column sub-assemblies; the experimental outcomes have been exploited to validate a finite element (FE) model developed in Abaqus and used to numerically perform the monotonic loading simulations of 30 joints. Afterwards, starting from the extracted information about stiffness, a regression analysis was carried out to define the coefficient of a design equation analytically derived applying the component method approach. The regression analysis is characterized by a coefficient of variation equal to 0.19.
In the last few decades, increasing efforts have been devoted to the development of beam-to-column connections able to accommodate the local ductility demand dissipating, contemporaneously, the seismic input energy. Among the typologies proposed, the so-called RBS (Reduced Beam Section) has gained wide acceptance in the construction market, leading to easy-to-construct and cost-effective solutions. As an alternative, new proposals based on the inclusion of friction devices in beam-to-column joints have recently been made. Such a practice has the merit, in case of destructive events, of exhibiting wide and stable hysteretic cycles concentrating damage in elements that undergo only minor yielding. Both RBS and friction joints have been widely studied, carrying out experimental tests on sub-assemblies investigating their cyclic rotational response. Nevertheless, the available experimental results on full-scale structures equipped with these connections are still quite limited. This is the reason why two experimental campaigns aimed at performing pseudo-dynamic testing of a full-scale two-storey steel building equipped with RBS and friction connections have been planned at the STRENGTH (STRuctural ENGineering Test Hall) Laboratory of the University of Salerno. The first experimental campaign with the structure equipped with RBSs has already been performed; the connections showed higher resistance than expected, and exhibited brittle fracture due to cyclic fatigue. The second campaign has not yet been carried out, but in this paper the blind analysis of the supposed behavior is reported. It is expected that the friction joints allow to dissipate the seismic input energy without any structural damage in the members, but only through the friction pads of the devices, which can be easily replaced at the end of a severe seismic event.
This manuscript explores the stiffness and strength of Square Hollow Section (SHS) tubes subjected to localised transverse actions applied to the open side of a rectangular hole created using 3D laser cutting technology (3D-LCT). Understanding the behaviour of this specific detail is crucial as it is a key component in the connections between SHS columns and passing-through IPE beams. The methodology employed in this manuscript involved developing analytical equations to predict both stiffness and strength of this structural element. The provided equations are presented in a straightforward manner and were deduced by applying elasticity principles to structural components. To validate these equations, a parametric analysis was conducted, simulating the response of 27 distinct geometric configurations of the analysed structural detail thanks to the Finite Element (FE) software. Their accuracy was confirmed by comparing the results of these simulations with the outcomes derived from the formulated equations. The primary findings indicated that the proposed equations could predict the stiffness and strength of the studied detail with an average ratio close to 1 when comparing predicted and numerical results, and a coefficient of variation of approximately 10%.