This paper proposes a new efficient model for the prediction of low-amplitude ground-borne vibrations in buildings. The model takes into account the three-dimensional nature of the building structure by analytical and semianalytical means, making it ideal for performing parametric studies or large-scale vibrations predictions. Its formulation assumes that the principal component in floor vibrations is the vertical one and assumes that the vibrations are transmitted to the various floors through the building columns. The correctness of the model is tested by comparing, in two 3-story building examples, its results with those obtained using a numerical model. Results regarding the isolation efficiency of implementing a thicker lower floor or columns with a larger cross section are also presented. The building-soil coupling is formulated considering piled foundations in a stratified soil. To ensure the computational efficiency of the calculations, the piles’ response to an incident wavefield is modeled considering the Novak pile model for a layered half-space. Finally, a study of the importance of the soil mechanical parameters in the considered problem is conducted using the building-soil coupled model.
10 May 2022 in Computer Methods in Applied Mechanics and Engineering
The assessment of the dynamic behaviour of resilient elements can be performed using the indirect method as described in the standard ISO 10846-3. This paper presents a methodology for control the error on the estimation of the frequency response functions (FRF) required for the application of the indirect method when sweep sine excitation is used. Based on a simulation process, this methodology allows for the design of the sweep sine excitation parameters, i.e., the sweep rate and the force amplitude, to control three types of errors associated to the experimentally obtained FRF in the presence of background noise: a general error of the FRF in a selected frequency range, and the errors associated to the amplitude and the frequency of the FRF resonance peak. The signal processing method used can be also tested with this methodology. The methodology has been tested in the characterisation of two different resilient elements: an elastomer and a coil spring. The simulated error estimations has been found to be in good agreement with the errors found in the measured FRF. Furthermore, it is found that for large signal-to-noise ratios, both sweep rate and force amplitude significantly affect the FRF estimation error, while, for small signal-to-noise ratios, only the force amplitude can control the error efficiently. The current methodology is specially interesting for laboratory test rigs highly used for the dynamic characterisation of resilient elements which are required to operate efficiently, since it can be used for minimising test times and providing quality assurance. Moreover, the application of this methodology would be specially relevant when characterisation is done in noisy environments.