A novel two-dimensional (2-D) periodic structure on the ablated hole wall is formed by using the method of single-beam femtosecond laser pulses irradiating a titanium target. This 2-D structure on the ablated surface, after consecutive irradiation of 10000 pulses, presents different spatial periods which characters a 1500 nm period along the hole wall in the vertical direction and a 400 nm period in the azimuthal direction of the hole. The reported experimental results can be well interpreted by a prophetic theoretical model of Bonch-Bruevich (A. M. Bonch-Bruevich et al., Opt. Eng. 31, 718 (1992)).
We study the ultrafast dynamics of the multiband iron-based superconductor via time-resolved optical reflectivity. We observe a long-lived 5- GHz oscillation of the reflection changes within the superconducting regime. We assign this low-frequency oscillation to a soft Leggett mode associated with the collective fluctuation of multiple phase differences between Cooper pair condensates. Our observation evidences the presence of the time-reversal-symmetry breaking state in superconducting .
Superhydrophobic surfaces are important in many applications owing to their special properties such as self-cleaning, anti-icing, antibacterial, and anti-fogging. In this paper, a micro/nano hierarchical superhydrophobic surface with a low roll-off angle was created on 304 stainless steel. The water contact angle was measured to be 152° with a roll-off angle of 7.3°. Firstly, microscale bumps were created by femtosecond laser irradiation. Secondly, zinc oxide (ZnO) nanowires were fabricated on the laser-induced bumps using a hydrothermal synthesis method. Results show that after laser treatment and ZnO nanostructuring, the stainless steel surface became superhydrophobic. However, the roll-off angle of this hierarchical structure surface was larger than 90°. To reduce the surface activity, trimethoxy silane hydrophobic coating was applied. A 7.3° roll-off angle was achieved on the coated surface. The underlying mechanism was discussed. The hydrophobic ZnO structured surface can help prevent bacterial contamination from water, which is important for implants. Thus, for biomedical applications, the antibacterial property of this hierarchical surface was examined. It was found that the antibacterial property of sample surfaces with ZnO nanowires were significantly increased. The optical density (OD) of Escherichia coli (E. coli) attached to the original surface was 0.93. For the micro-structured surface (with bumps), the OD was 0.9, and for the hierarchical surface (with bump & nanowires), it was 0.54. For nanostructured ZnO nanowire surface, the OD was only 0.09. It demonstrates good antibacterial properties of ZnO nanowires.
The films of few-layer graphene are formed through laser exfoliation of a highly ordered pyrolytic graphite (HOPG), without a catalytic layer for the growth process. The femtosecond (fs) laser exfoliation process is investigated at different laser fluences and substrate temperature. For fs laser exfoliation of HOPG, the few-layer graphene is obtained at 473 K under an optimal laser fluence. The formation of few-layer graphene is explained by removal of intact graphite sheets occurred by an optimal laser fluence ablation. The new insights may facilitate the controllable synthesis of large area few-layer graphene.