The need for energy and the increasing importance of climate change mitigation are leading to a conversion from conventional to renewable energy sources. Solar photovoltaic (PV) power has seen the most significant increase among all renewable energy sources. However, most of these installations are land-based, significantly changing global land use (LU). The real impacts, whether positive or negative, are poorly understood. This study was undertaken to have a better understanding of the impacts of solar parks on the microclimate and vegetation dynamics. First, different solar parks were visited to take measurements of the surface temperature (T_surf), photosynthetic active radiation (PAR), air temperature (T_air), and humidity (RH) to quantify the microclimate and perform a vegetation relevé. The measurements were taken at different positions: underneath, in between, and outside solar panels. For vegetation, the data were first converted to diversity indices, which in turn contributed to a multi-indicator land use impact assessment that evaluated effects on vegetation, biodiversity, soil and water. Solar parks had clear effects on microclimate: if the panels were high enough from the ground, they could lower the T_surf by providing shade and enough airflow. Additionally, the multidimensional functional diversity (FD) analysis of the vegetation indicated that there was less light at a higher humidity and lower temperature underneath the panels. Interestingly, the species underneath the panels also preferred a lower pH and a higher nitrogen level. Finally, the land use impact assessment found that the total land use impact for a wheat field was higher than that of the solar park, which suggests that the conversion of conventional intensive agriculture to a solar park would be beneficial.

Recently, the severe intensification of atmospheric carbon has highlighted the importance of urban tree contributions in atmospheric carbon mitigations in city areas considering sustainable urban green planning and management systems. Explicit and timely information on urban trees and their roles in the atmospheric Carbon Stock (CS) are essential for policymakers to take immediate actions to ameliorate the effects of deforestation and their worsening outcomes. In this study, a detailed methodology for urban tree CS calibration and mapping was developed for the small urban area of Sassuolo in Italy. For dominant tree species classification, a remote sensing approach was applied, utilizing a high-resolution WV3 image. Five dominant species were identified and classified by applying the Object-Based Image Analysis (OBIA) approach with an overall accuracy of 78%. The CS calibration was done by utilizing an allometric model based on the field data of tree dendrometry—i.e., Height (H) and Diameter at Breast Height (DBH). For geometric measurements, a terrestrial photogrammetric approach known as Structure-from-Motion (SfM) was utilized. Out of 22 randomly selected sample plots of 100 square meters (10 m × 10 m) each, seven plots were utilized to validate the results of the CS calibration and mapping. In this study, CS mapping was done in an efficient and convenient way, highlighting higher CS and lower CS zones while recognizing the dominant tree species contributions. This study will help city planners initiate CS mapping and predict the possible CS for larger urban regions to ensure a sustainable urban green management system.

Currently, the worsening impacts of urbanizations have been impelled to the importance of monitoring and management of existing urban trees, securing sustainable use of the available green spaces. Urban tree species identification and evaluation of their roles in atmospheric Carbon Stock (CS) are still among the prime concerns for city planners regarding initiating a convenient and easily adaptive urban green planning and management system. A detailed methodology on the urban tree carbon stock calibration and mapping was conducted in the urban area of Brussels, Belgium. A comparative analysis of the mapping outcomes was assessed to define the convenience and efficiency of two different remote sensing data sources, Light Detection and Ranging (LiDAR) and WorldView-3 (WV-3), in a unique urban area. The mapping results were validated against field estimated carbon stocks. At the initial stage, dominant tree species were identified and classified using the high-resolution WorldView3 image, leading to the final carbon stock mapping based on the dominant species. An object-based image analysis approach was employed to attain an overall accuracy (OA) of 71% during the classification of the dominant species. The field estimations of carbon stock for each plot were done utilizing an allometric model based on the field tree dendrometric data. Later based on the correlation among the field data and the variables (i.e., Normalized Difference Vegetation Index, NDVI and Crown Height Model, CHM) extracted from the available remote sensing data, the carbon stock mapping and validation had been done in a GIS environment. The calibrated NDVI and CHM had been used to compute possible carbon stock in either case of the WV-3 image and LiDAR data, respectively. A comparative discussion has been introduced to bring out the issues, especially for the developing countries, where WV-3 data could be a better solution over the hardly available LiDAR data. This study could assist city planners in understanding and deciding the applicability of remote sensing data sources based on their availability and the level of expediency, ensuring a sustainable urban green management system.

For the last few decades, there have been a lot of studies recognising the significant roles of the urban trees as a high-quality carbon sink. This work is a preliminary study about how remote sensing and photogrammetry could be useful tools to identify urban trees for the purpose of Carbon Storage (CS) computation in urban areas. Our first study area is a typical urban park located in Sassuolo, a municipality in the northern part of Italy in the so-called “Pianura Padana”. We measured the tree Height (H) and the Diameter at Breast Height (DBH), required for the calibration of the CS, based on the tree allometry during the field data collection along with the constructing a 3D model through the photogrammetric approach. A high-resolution WorldView (WV) 3 satellite image of the same area, was classified using an object-oriented approach to count the number of trees varied with different species. This preliminary study will enhance the possibilities of the application of these approaches in case of the larger urban areas to ascertain the accuracy of the tree CS calibration.

Morphometric traits are closely linked to body condition, health, welfare, and productivity in livestock. In recent years, contactless 3D reconstruction technologies have been increasingly adopted to improve the accuracy and efficiency of morphometric evaluations. Conventional approaches for 3D reconstruction mainly employ Light Detection and Ranging (LiDAR) or photogrammetry. In contrast, emerging Artificial Intelligence (AI)-based methods, such as Neural Surface Reconstruction, 3D Gaussian Splatting, and Neural Radiance Fields, offer new opportunities for high-fidelity digital modeling. Smartphones’ affordability represents a cost-effective and portable platform for deploying these advanced tools, potentially supporting enhanced agricultural performance, accelerating sector digitalization, and thus reducing the urban–rural digital gap. This preliminary study assessed the viability of using smartphone-based LiDAR, photogrammetry, and AI models to obtain body measurements of Marchigiana cattle. Five morphometric traits manually collected on animals were compared with those extracted from smartphone-based 3D reconstructions. LiDAR measurements offer more consistent estimates, with relative error ranging from −1.55% to 4.28%, while photogrammetry demonstrated accuracy ranging from 0.75 to −14.56. AI-based models (NSR, 3DGS, NeRF) reported more variability between accuracy results, pointing to the need for further refinement. Overall, the results highlight the preliminary potential of portable 3D scanning technologies, particularly LiDAR-equipped smartphones, for non-invasive morphometric data collection in cattle.

Small landscape elements are critical in ecological systems, encompassing vegetated and non-vegetated features. As vegetated elements, hedgerows contribute significantly to biodiversity conservation, erosion protection, and wind speed reduction within agroecosystems. This study focuses on the semi-automatic extraction of hedgerows by applying the Object-Based Image Analysis (OBIA) approach to two multispectral satellite datasets. Multitemporal image data from PlanetScope and Copernicus Sentinel-2 have been used to test the applicability of the proposed approach for detailed land cover mapping, with an emphasis on extracting Small Woody Elements. This study demonstrates significant results in classifying and extracting hedgerows, a smaller landscape element, from both Sentinel-2 and PlanetScope images. A good overall accuracy (OA) was obtained using PlanetScope data (OA = 95%) and Sentinel-2 data (OA = 85%), despite the coarser resolution of the latter. This will undoubtedly demonstrate the effectiveness of the OBIA approach in leveraging freely available image data for detailed land cover mapping, particularly in identifying and classifying hedgerows, thus supporting biodiversity conservation and ecological infrastructure enhancement.