Energy storage is one of the main challenges to address in the near future—in particular due to the intermittent energy produced by extensive renewable energy production plants. The use of hydrides for this type of energy storage has many positive aspects. Hydride-based systems consist of absorption and desorption reactions that are strongly exothermic and endothermic, respectively. Heat management in the design of hydrogen storage tanks is an important issue, in order to ensure high-level performance in terms of the kinetics for hydrogen release/uptake and reasonable storage capacity. When loose powder is used, material in the form of pellets should be considered in order to avoid detrimental effects including decreased cycling performance. Moreover, sustainable materials in large-scale hydrogen reactors could be recovered and reused to improve any life cycle analysis of such systems. For these reasons, magnesium hydride was used in this study, as it is particularly suitable for hydrogen storage due to its high H2 storage capacity, reversibility and the low costs. Magnesium hydride was ball-milled in presence of 5 wt % Fe as a catalyst, then compacted with an uniaxial press after the addition of expanded natural graphite (ENG). The materials underwent 45 cycles in a Sievert’s type apparatus at 310 °C and eight bar, in order to study the kinetics and cycling stability. Scanning electron microscopy was used to investigate microstructural properties and failure phenomena. Together with Rietveld analysis, X-ray diffraction was performed for phase identification and structural information. The pellets demonstrated suitable cycling stability in terms of total hydrogen storage capacity and kinetics.
In order to improve the hydrogenation properties of the MgH2, various concentration of rutile Titanium Oxide (TiO2) (X wt%= 5, 10, 15 wt %) is added to MgH2 by ball milling and the catalytic effect of TiO2 on hydriding/dehydriding properties of MgH2 has been investigated. Result shows that the TiO2 significantly reduced onset temperature of desorption. Onset temperature as low as 190 °C were observed for the MgH2−15 wt% TiO2 sample which is 60 °C and 160 °C lower than the as-milled and as-received MgH2. Fromm the Kissinger plot the activation energy of 15 wt% TiO2 added sample is calculated to be -75.48 KJ/mol. These results indicate that the hydrogenation properties of MgH2–TiO2 have been improved compared to the as-milled and as-received MgH2. Furthermore, XRD and XPS were performed to characterize the structural evolution upon milling and dehydrogenation.