This paper describes a large tuning range low phase noise voltage-controlled ring oscillator (ring VCO) based on a different cascade voltage logic delay cell with current-source load to change the current of output node. The method for optimization is presented. Furthermore, the analysis of performance of the proposed ring VCO is confirmed by the measurement results. The three-stage proposed ring VCO was fabricated in the 180-nm CMOS process of SMIC. The measurement results show that the oscillator frequency of the ring VCO is from 0.770 to 5.286 GHz and the phase noise is 97.93 dBc/Hz at an offset of 1 MHz from 5.268 GHz with a total power of 15.1 mW from a 1.8 V supply while occupying only 0.00175 mm2 of the core die area.
26 July 2022 in EURASIP Journal on Wireless Communications and Networking
Millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems allow for a data transmission rate of gigabits per second owing to the large bandwidth available in the mmWave spectrum and the antenna gains provided by the massive MIMO system. However, hybrid precoding with high complexity and low spectral efficiency cannot address the challenge of high cost and power consumption of RF chains of multi-user systems. In this paper, we propose a low-complexity hybrid precoding scheme for downlink multi-antenna multi-user mmWave massive MIMO systems, aiming to enhance the sum spectral efficiency (SSE) performance. We first extend the dimension of the analog precoding matrix into a square matrix and find the optimal analog combiner by selecting some of the discrete Fourier transform (DFT) bases, which enhances the equivalent baseband channel matrix gain. Then, we directly aggregate the channel gain through the equal gain transmission (EGT) method to ensure the frequency efficiency performance. Finally, we propose an improved BD scheme to design the digital precoder and combiner to reduce the inter-user interference. We consider both the mmWave channel and the Rayleigh channel to evaluate the performance of the proposed algorithm. The simulation results verify that the proposed scheme enjoys near-optimal achievable sum spectrum efficiency and BER performance in both the mmWave channel and Rayleigh channel and performs even better in Rayleigh channel than in the mmWave channel.
Long Range (LoRa) has become one of the most promising physical layer technologies for the Internet of Things (IoT) ecosystem. Although it manifests low-power consumption and long-distance communication, LoRa encounters a large number of collisions in the IoT environment, which severely affects the system’s throughput and delay performance. In this paper, a code division carrier sense multiple access (CD/CSMA) protocol that resolves the traditional channel collision problem and implements multi-channel transmission is proposed for the LoRa medium access control (MAC) layer. To reduce data transmission delay and maximize the throughput of the system, the adaptive p-persistent CSMA protocol divides the channel load into four states and dynamically adjusts the data transmission probability. Then, to reduce channel collisions significantly, the code division multiple access (CDMA) protocol is performed on different channel states. Moreover, the combination of the proposed adaptive p-persistent CSMA protocol and the CDMA successfully reduces the number of data retransmissions and makes LoRa more stable. The simulation results demonstrate that the proposed adaptive p-persistent CD/CSMA protocol can achieve near-optimal and occasionally even better performance than some conventional MAC protocols, especially in a heavy load channel.
1 June 2022 in Journal of Intelligent & Fuzzy Systems: Applications in Engineering and Technology
The occlusion in the real feedlot environment is ubiquitous, and the current research based on the cattle face recognition under occlusion conditions is almost non-existent. Thus, an attention mechanism module with high accuracy and low model complexity is designed to incorporate into MobileNet so that the cattle face under occlusion can be identify accurately, which is the RGB images captured in the ranch environment. In this paper, we also construct a Simmental cattle face image dataset for data modeling and method evaluation, which contains 10,239 images of 103 cattle. The experimental results show that when the occluder is in the upper left and lower right corner, if the occlusion rate is less than 30%, the value of Top_1 reaches more than 90%; if it is less than 50%, the value of Top_1 is more than 80%. Even if the middle part occludes lots of important information, the occlusion rate of 40% has an accuracy of more than 80%. Furthermore, comparing the proposal model with MobileNet, the parameter and model size are equal, and the amount of calculation as a cost increase a little. Therefore, the proposal model is suitable to transplant to the embedded system in the future.
1 December 2013 in Journal of Circuits, Systems and Computers
In this paper, the SIFT feature which has the scale rotation invariant are used to recognize the face. At the same time, in order to improve the robustness of SIFT under different expressions and gestures, the fisher discriminant is used to perform face matching. Taking into account that the LBP operator with light-insensitive dimension reduction is the global feature, and it will reflect the overall characteristics of the face. The two algorithms have their own advantages and disadvantages, and finally use the improved DS-evidence theory for decision-level information fusion, it will improve the robustness of face recognition in complex conditions. Experimental results show that the method has a certain improvement in the recognition rate compared with the single feature descriptors.