Herein, we carefully investigate the effect of nitrogen doping in the equiatomic CoCrFeMnNi high-entropy alloy (HEA) on the microstructure evolution and mechanical properties. After homogenization (1100 °C for 20 h), cold-rolling (reduction ratio of 60%) and subsequent annealing (800 °C for 1 h), a unique complex heterogeneous microstructure consisting of fine recrystallized grains, large non-recrystallized grains, and nanoscale Cr₂N precipitates, were obtained in nitrogen-doped (0.3 wt.%) CoCrFeMnNi HEA. The yield strength and ultimate tensile strength can be significantly improved in nitrogen-doped (0.3 wt.%) CoCrFeMnNi HEA with a complex heterogeneous microstructure, which shows more than two times higher than those compared to CoCrFeMnNi HEA under the identical process condition. It is achieved by the simultaneous operation of various strengthening mechanisms from the complex heterogeneous microstructure. Although it still has not solved the problem of ductility reduction, as the strength increases because the microstructure optimization is not yet complete, it is expected that precise control of the unique complex heterogeneous structure in nitrogen-doped CoCrFeMnNi HEA can open a new era in overcoming the strength–ductility trade-off, one of the oldest dilemmas of structural materials.

In this study, laser surface remelting of an AlCoCrFeNi_2.1 high-entropy alloy was performed using a Yb:YAG laser. The effects of laser surface remelting on the phase structure, microstructure, Vickers hardness, frictional wear properties, and corrosion resistance of the high-entropy alloy were investigated. The remelted layer of the AlCoCrFeNi_2.1 high-entropy alloy was produced by remelting at 750 W laser power and formed a good metallurgical bond with the substrate. The X-ray diffraction results showed that the 750 W remelted layer consisted of face-centered cubic and body-centered cubic phases, which were consistent with the phases of the as-cast AlCoCrFeNi_2.1 high-entropy alloy, and a new phase was not generated within the remelted layer. Laser surface remelting is very effective in refining the lamellar structure, and the 750 W remelted layer shows a finer lamellar structure compared to the matrix. The surface hardness and wear resistance of the AlCoCrFeNi_2.1 high-entropy alloy were substantially improved after laser surface remelting. In a 3.5 wt.% NaCl solution, the laser-remelted surface had a larger self-corrosion potential and smaller self-corrosion current density, and the corrosion resistance was better than that of the as-cast high-entropy alloy.

In this study, Al-17%Si alloys were dual modified by fine-grained structural materials (FSM) according to structural heredity. Microstructure and thermal analyses were undertaken to study the modification effect of the FSM master alloy on primary and eutectic Si. Primary Si is refined to a smaller size and eutectic Si is modified from needle-like to fibrous shape after FSM master alloy addition. The optimal content of FSM master alloy is 20% and the holding time is 15min. Finer FSM master alloy leads to finer Al-17%Si alloy microstructure and more area percentage of α-Al. DSC analyses results show that FSM master alloy can raise the precipitation temperatures of primary and eutectic Si, meanwhile it can reduce the latent heat of Si solidification process.