Inevitable mistuning in cyclic bladed disk structures would cause vibration amplification phenomena that seriously reduce the reliability of the bladed disk. The ability to accurately and quickly predict the dynamic responses is critical to investigating the dynamic behavior of the mistuned system. However, it is still challenging because the mistuned responses are extremely sensitive to the random mistuning parameters. In this work, a novel mistuned system deep neural network model (MS-DNN) is presented to predict the dynamic responses of mistuned bladed disks through the mistuning parameters for both the lumped parameter model and the large-scale finite element (FE) model, which decouples the vibration equations of the mistuned system and uses a neural network to replace the coupling process. MS-DNN is divided into two levels, namely, the blade and the disk. The blade-level neural networks are used for forward and backward propagation of mistuning parameters in the different blades, and the disk-level neural network is used to replace the physical coupling process in the disk of multiple mistuning parameters from individual blades, with data transmission between the neural networks via blade–disk boundary nodes. The expected physical response of the blade tip is predicted through MS-DNN. All neural networks in MS-DNN show high prediction accuracy on both training sets and unknown test sets. For the FE model of the industrial bladed disk, the effect of the number of boundary nodes selected as the data interface between neural networks on the prediction accuracy is also investigated. The results show that, for unknown test data, the predicted response has an [ ] value of 0.998 versus the actual response with an amplification factor error of less than 0.388%.
Model updating plays an important role in dynamics modeling with high accuracy, which is widely used in mechanical engineering. In this paper, a model updating method using frequency response function (FRF) is proposed based on Sherman–Morrison formula, in which only the initial FRFs and parameter perturbations are employed to calculate the sensitivity avoiding repeated finite element (FE) analyses and improving the computational efficiency. Firstly, the sensitivity of FRFs to the design parameters is calculated by Sherman–Morrison formula based on the QR decomposition of the system dynamic stiffness matrix variation after parameter perturbations, then the influence of damping on the amplitude of FRFs is considered to select an appropriate frequency range, and finally conduct the model updating according to the sensitivity of the FRFs. By employing simulation examples of a truss and a solar wing and the experiment of an aluminum frame, the updating error is still within ±1.00% in the condition of 5% random white noise, which shows the proposed method has high accuracy and a certain anti-noise capability. When only a few numbers of frequency points are selected near the resonance peak of the FRFs, the result shows that selecting the appropriate frequency range and points can reduce the computational cost. The results of the experiment study show that the proposed method can effectively identify the structural parameters. The above results verify the feasibility and effectiveness of proposed model updating method using FRFs.
11 February 2023 in International Journal of Mechanical Sciences
The vibration characteristics of bolted structures are crucially affected by the pre-tightening torque. An approach for identifying the pre-tightening torque dependent stiffness parameters of bolted joints is proposed in this paper. Firstly, the interface of the bolted joint is characterized by the thin layer element with the isotropic material property, and the parameter value of the property is assigned relative to the distance from the center of the bolt; the influence of the bolt is ignored. Secondly, the model updating method is adopted to identify the parameters of thin layer elements using experimental data, and modal data under different values of pre-tightening torque in the range of 2 N·m~22 N·m are obtained; the torque wrench is used to determine the pre-tightening torque in the modal test. Finally, after identifying the material parameters using partial experimental data on pre-tightening torque range, the empirical equation of the interface parameters with the pre-tightening torque parameter is obtained by curve fitting and the rest of the experimental data are used to verify the accuracy of the fitted empirical equations. It is concluded that this method can obtain all the parameters of the equivalent thin layer elements within a certain range of pre-tightening torque, which can provide a reference for the empirical modeling of bolted structures, improve modeling efficiency and reflect the characteristic performance of real structural dynamics.