A robot’s ability to grasp moving objects depends on the availability of real-time sensor data in both the far-field and near-field of the gripper. This research investigates the potential contribution of tactile sensing to a task of grasping an object in motion. It was hypothesised that combining tactile sensor data with a reactive grasping strategy could improve its robustness to prediction errors, leading to a better, more adaptive performance. Using a two-finger gripper, we evaluated the performance of two algorithms to grasp a ball rolling on a horizontal plane at a range of speeds and gripper contact points. The first approach involved an adaptive grasping strategy initiated by tactile sensors in the fingers. The second strategy initiated the grasp based on a prediction of the position of the object relative to the gripper, and provided a proxy to a vision-based object tracking system. It was found that the integration of tactile sensor feedback resulted in a higher observed grasp robustness, especially when the gripper–ball contact point was displaced from the centre of the gripper. These findings demonstrate the performance gains that can be attained by incorporating near-field sensor data into the grasp strategy and motivate further research on how this strategy might be expanded for use in different manipulator designs and in more complex grasp scenarios.
Epidemiological analysis has revealed key insights into the frequency, severity, and circumstances surrounding subway-to-pedestrian incidents; however, there remains a lack of available impact test data specific to this impact type that can be used in modelling and countermeasure design studies. To address this gap, nine controlled impact tests were conducted using a cylindrical headform to derive force–penetration relationships for foam, as well as foam encased in 1 mm aluminium or 3 mm ABS shells. These relationships were validated in MADYMO multibody simulations. Building on a previous multibody computational study of subway-to-pedestrian collisions this research evaluates three passive countermeasure designs using a reduced simulation test matrix: three impact velocities (8, 10, and 12 m/s) and a trough depth of 0.75 m. In subway collisions, due to the essential rigidity of a subway front relative to a pedestrian, it is the pedestrian stiffness characteristics that primarily dictate the contact dynamics, as opposed to a combined effective stiffness. However, the introduction of energy-absorbing countermeasures alters this interaction. Results indicate that modular energy-absorbing panels attached to the train front significantly reduced the Head Injury Criterion (HIC) (by 90%) in the primary impact and pedestrian-to-wheel contact risk (by 58%), with greater effectiveness when a larger frontal area was covered. However, reducing primary impact severity alone did not substantially lower total fatal injury risk. A rail-guard design, used in combination with frontal panels, reduced secondary impact severity and led to the largest overall reduction in fatal injuries. This improvement came with an expected increase in hospitalisation-level outcomes, such as limb trauma, reflecting a shift from fatal to survivable injuries. These findings demonstrate that meaningful reductions in fatalities are achievable, even with just 0.5 m of available space on the train front. While further development is needed, this study supports the conclusion that subway-to-pedestrian fatalities are preventable.