At the beginning of the present century it has been demonstrated that nanocrystalline titanium (NC-Ti) can be fabricated by hydrostatic extrusion (HE) which is one of the severe plastic deformation method. NC-Ti obtained in such a way exhibited excellent mechanical properties. The influence of HE on the microstructure and mechanical properties of titanium Grade 2 was first analyzed in 2005. In this study the progress in HE of titanium has been described. However, there are tribological and technological challenges encountered in HE of titanium. They can practically be eliminated by modifying the surface of Ti billets with aluminum coatings. Another important issue in extrusion is the optimum value of the accumulated strain necessary for grain refinement of titanium. Our results have shown that this value must exceed 3 to obtain nanocrystalline Ti. The results obtained indicate that HE permits producing NC-Ti rods with the diameter up to 10 mm.

The study is concerned with the bimetallic plate composed of the Ti6Al4V and Inconel 625 alloys. The alloys were joined together using the explosive method with the aim to produce a bimetallic joint. The structure and the mechanical properties of the as-received raw Ti6Al4V and Inconel 625 alloys, the Ti6Al4V/Inconel 625 joint, and the joint after annealing (600 °C for 1 h) were examined. The samples observations were performed using a light microscope and a scanning electron microscope. The mechanical properties were estimated by microhardness measurements, tensile tests, and three-point bending tests. Moreover, the deformation strengthening of the metals and the strength of the joint were analyzed. The explosive process resulted in a good quality bimetallic joint. Both sheets were deformed plastically and the joint surface between the alloys had a wavy shape. In the area of the joint surface, the hardness was increased. For example, the annealing at 600 °C for 1 h resulted in changes of the microhardness in the entire volume of the samples and in changes of the morphology of the joint surface. In three-point bending tests, the samples were examined in two opposite positions (Ti6Al4V on the top or Inconel 625 on the top). The results indicated to depend on the position in which the sample was tested.