Optical coatings based on multilayers are prepared. The dependence of the refractive index of SiO2, TiO2, HfO2, and ZrO2 on the conditions during thin film evaporation (e.g., oxygen partial pressure, substrate temperature) and upon post-annealing are investigated in detail. For coatings to be stable under intensive laser irradiation, post-heating of the evaporated films is necessary. The correlation between mass density and refractive index is analysed on the basis of a model comprising compact grains (i.e., amorphous or crystalline) and pores filled with air or water. The properties of the whole film are discussed on the basis of an effective-medium model, whereas the properties of a single grain are derived from a general refractivity formula valid for homogeneously distributed dipoles.
Highly conductive TiO2 films with different Nb doping levels (up to 5 at%) were prepared by reactive DC magnetron sputtering under precise control of the oxygen partial pressure. They were deposited on unheated substrates, covered with a protective Si3N4 layer, and subsequently annealed at 300 °C. The doping efficiency of Nb is greater than 90%. Conductivity is a maximum for a partly oxidized target in the transition range. The best films exhibit a resistivity of 630 µΩ cm and a mobility of 7.6 cm2/Vs combined with a high transparency above 70%. Comparing the behavior of undoped and Nb-containing films, intrinsic limits of the conductivity in the TiO2−x:Nb system could be observed, and a consistent model explaining these findings is presented. The conductivity is limited—by decreasing electron density due to Nb oxidation—by increasing incorporation formation of Nb2O5 clusters as scattering centers with increasing oxygen partial pressure and Nb concentration, by a transition from the crystalline to the amorphous state of the films below a critical oxygen partial pressure.
The classical theory to determine the interface wall energy from magnetization reversal experiments in exchange‐coupled double layers is reviewed and extended. From the energy balance three elementary reversal processes of one of the layers together with transition diagrams and corresponding reversal curves of ferrimagnetic A and P double layers are systematically derived. The wall energy can be determined from the minor loops of double layers without requiring parameters obtained on the individual layers. A novel type of partial magnetic reversal experiments is applied to amorphous rare‐earth transition‐metal bilayers. The results can be interpreted by assuming that the interface wall can move vertically through one layer and that common domains in both layers as well as separate domains may be nucleated. This can lead to asymmetric reversal loops, which make the evaluation of the wall energy density and the coercive force incorrect by the classical theory. Other asymmetries originate from the magnetic‐field dependence of the wall energy and from pinning effects at the interface. Such effects can explain some of the inconsistent values of coercive fields and interface wall energy that have been reported in the literature.