The aim of the present work was to investigate the feasibility of applying the molecular imprinting polymer technique to the detection of the mycotoxin deoxynivalenol (DON) using a surface plasmon resonance (SPR) transducer. A molecularly imprinted polypyrrole (MIPPy) film was prepared via electropolymerization of pyrrole onto a bare Au chip in the presence of a template DON molecule. Atomic force microscope SPR analysis showed that the MIPPy film was deposited homogeneously on the Au surface, with a thickness of 5 nm. The MIPPy–SPR sensor exhibited a linear response for the detection of DON in the range of 0.1–100 ng/mL (R2 = 0.988). The selectivity efficiency of the MIPPy film for DON and its acetylated analogs 3-ADON and 15-ADON was 100, 19, and 44%, respectively. The limit of detection for DON with the MIPPy–SPR for a standard solution was estimated at >1 ng/mL. These results suggest that the combination of SPR sensing with a MIPPy film as a synthetic receptor can be used to detect DON.
The food industry requires rapid and simple detection methods for preventing harm from pathogenic bacteria. Until now, various technologies used to detect foodborne bacteria were time-consuming and laborious. Therefore, we have developed an automated immunomagnetic separation combined with a colorimetric assay for the rapid detection of E. coli O157:H7 in food samples. The colorimetric detection method using enzymatic reaction is fascinating because of its simplicity and rapidity and does not need sophisticated devices. Moreover, the proposed procedures for the detection of bacteria in food take less than 3 h including pre-enrichment, separation and detection steps. First, target-specific immunomagnetic beads were introduced to contaminated milk in a pre-enrichment step. Second, the pre-enriched sample solution containing target bacteria bound on immunomagnetic beads was injected into an automated pretreatment system. Subsequently, the immunomagnetic beads along with target bacteria were separated and concentrated into a recovery tube. Finally, released β-galactosidase from E. coli O157:H7 after lysis was reacted with chlorophenol red β-galactopyranoside (CPRG) used as a substrate and the colorimetric change of CPRG was determined by absorbance measuring or the naked eye. By the proposed approach in this study, we could detect 3 × 102 CFU/mL of E. coli O157:H7 from a milk sample within 3 h.
Herein, we investigated the potential of plasma-activated water (PAW) as a wash solution for the microbial decontamination of cherry tomatoes. We analyzed the efficacy of PAW as a bactericidal agent based on reactive species and pH. Immersion for 5 min in PAW15 (generated via plasma activation for 15 min) was determined as optimal for microbial decontamination of fresh produce. The decontamination efficacy of PAW15 exceeded those of mimic solutions with equivalent reactive species concentrations and pH (3.0 vs. 1.7 log reduction), suggesting that the entire range of plasma-derived reactive species participates in decontamination rather than a few reactive species. PAW15-washing treatment achieved reductions of 6.89 ± 0.36, 7.49 ± 0.40, and 5.60 ± 0.05 log10 CFU/g in the counts of Bacillus cereus, Salmonella sp., and Escherichia coli O157:H7, respectively, inoculated on the surface of cherry tomatoes, with none of these strains detected in the wash solution. During 6 days of 25 °C storage post-washing, the counts of aerobic bacteria, yeasts, and molds were below the detection limit. However, PAW15 did not significantly affect the viability of RAW264.7 cells. These results demonstrate that PAW effectively inactivates microbes and foodborne pathogens on the surface of cherry tomatoes and in the wash solution. Thus, PAW could be used as an alternative wash solution in the fresh produce industry without cross-contamination during washing and environmental contamination by foodborne pathogens or potential risks to human health.
Silver nanoparticles (AgNPs) were synthesized using the whole plant of Duchesnea indica (DI) which was extracted in different solvents; the antimicrobial effects of the extract were investigated in this study. The extraction of DI was performed using three different solvents: water, pure ethanol (EtOH), and pure dimethyl sulfoxide (DMSO). AgNP formation was monitored by measuring the UV–Vis spectrum of each reaction solution. After synthesis for 48 h, the AgNPs were collected and the negative surface charge and size distribution of the synthesized AgNPs were measured using dynamic light scattering (DLS). The AgNP structure was determined by high-resolution powder X-ray diffraction (XRD) and the AgNP morphology was investigated using transmission electron microscopy (TEM). AgNP antibacterial activities were evaluated against Bacillus cereus, Staphylococcus aureus, Escherichia coli, Salmonella enteritidis, and Pseudomonas aeruginosa using the disc diffusion method. Additionally, minimum inhibitory concentration (MIC) and minimum bactericidal concentration (MBC) values were also determined. Biosynthesized AgNPs showed enhanced antibacterial activity against B. cereus, S. aureus, E. coli, S. enteritidis, and P. aeruginosa compared with that of pristine solvent extract. These results suggest that AgNPs synthesized from extracts of DI are promising antibacterial agents against pathogenic bacteria and can be further applied in the food industry.
Chitosan (CTS)/gelatin (GEL)/poly(vinyl alcohol) (PVA)-based composite films with different concentrations of Duchesnea indica extract (DIE) (6.25 and 25 mg/mL), an antimicrobial agent, were manufactured using a casting technique. Results indicated that elongation at break decreased as DIE was added at higher concentrations. Composite films showed no significant differences in thickness, tensile strength, and water vapor permeability. Scanning electron microscopy images revealed that DIE was successfully incorporated into film matrices to interact with polymers. The addition of DIE to the film inhibited the growth of S. aureus by up to 4.9 log CFU/mL. The inhibitory effect on S. aureus using DIE-incorporated coating applied to strawberries was greatest at room temperature storage for 24 h only when it was coated twice or more. The maximum inhibition in strawberries was 2.5 log CFU/g when they were coated twice and 3.2 log CFU/g when they were coated three times. The results of this study suggest that DIE could be used as a natural antimicrobial agent, and DIE-integrated CTS/GEL/PVA films or coatings have potential as a food packaging alternative for preventing foodborne pathogen contamination.
In this study, we describe the development of an automated immunomagnetic separation device combined with real-time polymerase chain reaction (PCR) for detecting foodborne bacteria. Immunomagnetic separation (IMS) is a well-known method for the separation and concentration of target bacteria from a large volume of food samples. Magnetic beads functionalized with an antibody provide selectivity for target bacteria such as Escherichia coli O157:H7. Moreover, compared to conventional methods, real-time PCR enables high-sensitivity detection of target bacteria. The method proposed in this study involves three steps: (1) pre-enrichment, (2) automated IMS and concentration of target bacteria, and (3) detection of target bacteria by real-time PCR. Using food samples with a working sample volume as large as 250 mL, the whole process only requires 3 h. As a result, target bacteria in the range of 101–102 colony-forming units per mg or g of sample can be detected in food samples, such as milk, ground beef, and cabbage, by using the proposed approach. We anticipate that the automated IMS system combined with real-time PCR will contribute to the development of a fully automated system for detecting foodborne bacteria and serve as a multi-tester for a variety of bacterial strains in the capacity of a sample-to-answer device in the near future.