Significance: Strong electrophilicity usually goes hand in hand with positive charge. In contrast, most negative ions behave like nucleophiles. Here we challenge this conventional wisdom by introducing an apparently counterintuitive idea that anions can, under well-defined circumstances, behave as superelectrophiles and even show superior binding strength and kinetic product stabilization in comparison with typical superelectrophilic cations. Emanating from the most stable gas-phase dianion [B12(CN)12]2−, synthesized here, we generate its superelectrophilic fragment anion [B12(CN)11]−, which binds Ar covalently at room temperature. This opens up additional directions for activation of inert compounds and elements.
31 May 2017 in Angewandte Chemie International Edition
The electron-induced chemistry of a resist material for extreme ultraviolet lithography (EUVL) consisting of Zn oxoclusters with methacrylate (MA) and trifluoroacetate (TFA) ligands (Zn(MA)(TFA)) has been studied. Electron energies of 80 eV and 20 eV mimic the effect of photoelectrons released by the absorption of EUV photons and low-energy secondary electrons (LESEs) produced by those photoelectrons. The chemical conversion of the resist is studied by mass spectrometry to monitor the volatile species that desorb during electron irradiation, combined with reflection absorption infrared spectra (RAIRS) measured before and after irradiation. The observed reactions are closely related to those initiated upon EUV absorption. Also, the conversion of the Zn(MA)(TFA) resist layer that is required in EUVL is achieved by a similar energy input upon electron irradiation. The dominant component of the desorbing gas is CO2, but CO detection also suggests Zn oxide formation during electron irradiation. In contrast, species deriving from the ligand side chains predominantly remain within the resist layer. RAIRS gives direct evidence that, during electron irradiation, CC bonds of the MA ligands are more rapidly consumed than the carboxylate groups. This supports that chain reactions occur and contribute to the solubility switch in the resist in EUVL. Remarkably, 20 eV electrons still evolve roughly 50% of the amount of the gas that is observed at 80 eV for the same electron dose. The present results thus provide complementary and new insight to the EUV-induced chemistry in the Zn(MA)(TFA) resist and point towards the important contribution of low-energy electrons therein.
Alkanes and [B12X12]2− (X = Cl, Br) are both stable compounds which are difficult to functionalize. Here we demonstrate the formation of a boron−carbon bond between these substances in a two-step process. Fragmentation of [B12X12]2− in the gas phase generates highly reactive [B12X11]− ions which spontaneously react with alkanes. The reaction mechanism was investigated using tandem mass spectrometry and gas-phase vibrational spectroscopy combined with electronic structure calculations. [B12X11]− reacts by an electrophilic substitution of a proton in an alkane resulting in a B−C bond formation. The product is a dianionic [B12X11CnH2n+1]2− species, to which H+ is electrostatically bound. High-flux ion soft landing was performed to codeposit [B12X11]− and complex organic molecules (phthalates) in thin layers on surfaces. Molecular structure analysis of the product films revealed that C−H functionalization by [B12X11]− occurred in the presence of other more reactive functional groups. This observation demonstrates the utility of highly reactive fragment ions for selective bond formation processes and may pave the way for the use of gas-phase ion chemistry for the generation of complex molecular structures in the condensed phase. Significance Functionalization of unreactive molecules is a significant chemical challenge relevant to the conversion of abundant feedstocks such as alkanes into high-value chemicals. Herein, we demonstrate a new mechanism of alkane functionalization by the substitution of a proton by an anion in an alkyl chain. The reactive anion used for this reaction is generated from a highly stable precursor. The reaction mechanism is established using experimental and computational approaches, and the products are collected in the condensed phase using high-flux mass-selected ion deposition. This paves the way for exploiting the properties of gaseous ions for the generation of complex molecular structures in the condensed phase.