In this paper, constant false alarm rate (CFAR) detector-based approaches are proposed for interference mitigation of Frequency modulated continuous wave (FMCW) radars. The proposed methods exploit the fact that after dechirping and low-pass filtering operations the targets' beat signals of FMCW radars are composed of exponential sinusoidal components while interferences exhibit short chirp waves within a sweep. The spectra of interferences in the time-frequency (t-f) domain are detected by employing a 1-D CFAR detector along each frequency bin and then the detected map is dilated as a mask for interference suppression. The proposed approaches are applicable to the scenarios in the presence of multiple interferences. Compared to the existing methods, the proposed methods reduce the power loss of useful signals and are very computationally efficient. Their interference mitigation performances are demonstrated through both numerical simulations and experimental results.

3-D imaging with irregular planar multiple-input-multiple-output (MIMO) arrays is discussed. Due to signal acquisition on irregular spatial sampling grids by using these antenna arrays, the fast Fourier transform (FFT)-based imaging algorithms cannot readily be used for image formation. To avoid the application of computationally intensive coherent summation algorithms such as filtered backprojection or Kirchhoff migration, we propose a nonuniform FFT (NUFFT)-based MIMO Range Migration Algorithm (i.e., NUFFT-based MIMO-RMA) for efficient microwave imaging. The algorithm exploits NUFFT to reconstruct the wavenumber-domain spectra related to each Fourier frequency. It is generic and applicable to 3-D imaging with irregular planar MIMO arrays. The effects of irregular spatial sampling and signal bandwidth on the imaging performance and computational efficiency of the proposed algorithm are analyzed. Finally, some numerical simulations and experimental results are presented to demonstrate the performance of the proposed imaging algorithm.

In this paper, the interference mitigation for Frequency Modulated Continuous Wave (FMCW) radar system with a dechirping receiver is investigated. After dechirping operation, the scattered signals from targets result in beat signals, i.e., the sum of complex exponentials while the interferences lead to chirp-like short pulses. Taking advantage of these different time and frequency features between the useful signals and the interferences, the interference mitigation is formulated as an optimization problem: a sparse and low-rank decomposition of a Hankel matrix constructed by lifting the measurements. Then, an iterative optimization algorithm is proposed to tackle it by exploiting the Alternating Direction of Multipliers (ADMM) scheme. Compared to the existing methods, the proposed approach does not need to detect the interference and also improves the estimation accuracy of the separated useful signals. Both numerical simulations with point-like targets and experiment results with distributed targets (i.e., raindrops) are presented to demonstrate and verify its performance. The results show that the proposed approach is generally applicable for interference mitigation in both stationary and moving target scenarios.

A novel matrix-pencil (MP)-based interference mitigation approach for frequency-modulated continuous-wave (FMCW) radars is proposed in this article. The interference-contaminated segment of the beat signal is first cut out, and then, the signal samples in the cutout region are reconstructed by modeling the beat signal as a sum of complex exponentials and using the MP method to estimate their parameters. The efficiency of the proposed approach for the interference with different parameters (i.e., interference duration, signal-to-noise ratio (SNR), and different target scenarios) is investigated by means of numerical simulations. The proposed interference mitigation approach is intensively verified on experimental data. Comparisons of the proposed approach with the zeroing and other beat-frequency interpolation techniques are presented. The results indicate the broad applicability and superiority of the proposed approach, especially in low SNR and long interference duration situations.

In this article, the interference mitigation (IM) problem is tackled as a regression problem. A prior-guided deep learning (DL)-based IM approach is proposed for frequency-modulated continuous-wave (FMCW) radars. Considering the complex-valued nature of radar signals, a complex-valued convolutional neural network, which is different from the conventional real-valued counterparts, is utilized as an architecture for implementation. Meanwhile, as the desired beat signals of FMCW radars and interferences exhibit different distributions in the time–frequency domain, this prior feature is exploited as a regularization term to avoid overfitting of the learned representation. The effectiveness and accuracy of our proposed complex-valued fully convolutional network (CV-FCN)-based IM approach are verified and analyzed through both simulated and measured radar signals. Compared with the real-valued counterparts, the CV-FCN shows a better IM performance with a potential of half memory reduction in low signal-to-interference-plus-noise ratio (SINR) scenarios. The average SINR of interfered signals has been improved from −9.13 to 10.46 dB. Moreover, the CV-FCN trained using only simulated data can be directly utilized for IM in various measured radar signals and shows a superior generalization capability. Furthermore, by incorporating the prior feature, the CV-FCN trained on only 1/8 of the full data achieves comparable performance as that on the full dataset in low SINR scenarios, and the training procedure converges faster.

Recently, frequency-modulated continuous-wave (FMCW) radar-based hand gesture recognition (HGR) using deep learning has achieved favorable performance. However, many existing methods use extracted features separately, i.e., using one of the range, Doppler, azimuth, or elevation angle information, or a combination of any two, to train convolutional neural networks (CNNs), which ignore the interrelation among the 5-D time-varying-range-Doppler-azimuth-elevation feature space. Although there have been methods using the 5-D information, their mining of the interrelation among the 5-D feature space is not sufficient, and there is still room for improvements. This article proposes a new processing scheme of HGR based on 5-D feature cubes that are jointly encoded by a 3-D fast Fourier transform (3-D-FFT)-based method. Then, a CNN is proposed by building two novel blocks, i.e., the spatiotemporal deformable convolution (STDC) block and the adaptive spatiotemporal context-aware convolution (ASTCAC) block. Concretely, STDC is designed to cope with hand gestures’ large spatiotemporal geometric transformations in the 5-D feature space. Moreover, ASTCAC is designed for modeling long-distance global relationships, e.g., relationships between pixels of the feature at the upper left corner and lower right corner, and exploring the global spatiotemporal context, in order to enhance the target feature representation and suppress interference. Finally, our presented method is verified on a large radar dataset, including 19 760 sets of 16 common hand gestures, collected by 19 subjects. Our method obtains a recognition rate of 99.53% on the validation dataset and that of 97.22% on the test dataset, which is significantly better than state-of-the-art methods.