Heating buildings with solar energy is challenged by the seasonal mismatch between solar availability and heating demand. Thermochemical energy storage is a promising technology to overcome this challenge because of its high energy density. In building applications, space requirement is also an important consideration. Therefore, both the storage space and collector areas are important considerations, with only the latter often being neglected in previous studies. This paper proposes a novel two-stage thermochemical heat pump heating system based on the working pair of NaOH/H₂O. We demonstrate that this system can work with a concentration difference (70% wt–30% wt) for the climate in hot summer and cold winter regions in China. The energy storage density based on the discharged solution is 363 kWh/m³. With this solar-driven thermochemical heat pump heating system, 35.13 m² of collectors and 10.48 tons of 70% wt NaOH solution are sufficient to complete a full charge–discharge cycle and meet the heating demand of a single-family house (winter space heating + DHW: 9370 kWh, summer DHW: 2280 kWh). The theoretical maximum storage for solution (discharged + water tank) is 32.47 m³. Compared with the sensible seasonal storage alternative, the collector area is reduced by 12.5% and the storage space is reduced by 59%, with a possible further reduction through optimization. With the potential to be further optimized for space saving, the two-stage solar–NaOH heat pump heating system is an energy-efficient and space-efficient heating system for buildings in the hot summer and cold winter regions of China.

Wind resistance optimization is crucial for enhancing the rotational speed of supergravity centrifuges. We conducted a study using computational fluid dynamics on the Centrifugal Hypergravity and Interdisciplinary Experiment Facility (CHIEF) under construction at Zhejiang University and validated it experimentally using a ZJU400gt centrifuge. Our findings indicate significant reductions in wind resistance through structural modifications of the CHIEF. Reducing the outer radius from 4650 to 4150 mm decreased wind resistance by 16%, primarily due to reduced effective viscosity in the wake region’s gases. More substantial reductions were achieved by lowering the height of the outer wall from 2200 to 1400 mm, which cut wind resistance by 25%. This height reduction suppressed vortex shedding and Kármán vortex street development via the Venturi effect. Adjustments to the roughness height of wall surfaces further decreased wind resistance, with minimal impact from arm roughness. A critical roughness height was identified, below which no further reductions in wind resistance could be attained. Notably, using disc-shaped arms reduced wind resistance by approximately 73% because of their minimal pressure–resistance components and predominant frictional resistance, highlighting their potential in future high-speed centrifuge designs.