This work introduces the potential synergistic toxicity of binary mixtures of pesticides and pharmaceuticals, which have been detected in substantial amounts in major river basins in South Korea. Different dose-response curve functions were employed in each experimental toxicity dataset for Aliivibrio fischeri. We tested the toxicity of 30 binary mixtures at two effect concentrations: high effect concentration [EC₅₀] and low effect concentration (EC₁₀) ranges. Thus, the toxicological interactions were evaluated at 60 effected concentration data points in total and based on model deviation ratios (MDRs) between predicted and observed toxicity values (e.g., three types of combined effects: synergistic (MDR > 2), additive (0.5 ≤ MDR ≤ 2), and antagonistic (MDR < 0.5)). From the 60 data points, MDRs could not be applied to 17 points, since their toxicities could not be measured. The result showed 48%-additive (n = 20), 40%-antagonistic (n = 17), and 12%-synergistic (n = 6) toxicity effects from 43 binaries (excluding the 17 combinations without MDRs). In this study, EC₁₀ ratio mixtures at a low overall effect range showed a general tendency to have more synergistic effects than the EC₅₀ ratio mixtures at a high effect range. We also found an inversion phenomenon, which detected three binaries of the combination of synergism at low concentrations and additive antagonism at high concentrations.

Four different manufactured surface-coated silver nanoparticles (AgNPs) with coating of citrate, tannic acid, polyethylene glycol, and branched polyethylenimine were used in this study. The toxicity of surface-coated AgNPs was evaluated by a luminous microbial array for toxicity risk assessment (LumiMARA) using multi-species of luminescent bacteria. The salt stability of four different AgNPs was measured by UV absorbance at 400 nm wavelength, and different surface-charged AgNPs in combination with bacteria were observed using scanning electron microscopy (SEM). Both branched polyethylenimine (BPEI)-AgNPs and polyethylene glycol (PEG)-AgNPs were shown to be stable with 2% NaCl (non-aggregation), whereas both citrate (Cit)-AgNPs and tannic acid (Tan)-AgNPs rapidly aggregated in 2% NaCl solution. The values of the 50% effective concentration (EC₅₀) for BPEI-AgNPs in marine bacteria strains (1.57 to 5.19 mg/L) were lower than those for the other surface-coated AgNPs (i.e., Cit-AgNPs, Tan-AgNPs, and PEG-AgNPs). It appears that the toxicity of AgNPs could be activated by the interaction of positively charged AgNPs with the negatively charged bacterial cell wall from the results of LumiMARA. LumiMARA for toxicity screening has advantageous compared to a single-species bioassay and is applicable for environmental samples as displaying ranges of assessment results.

The complex and dynamic nature of airborne fine particulate matter (PM_2.5) has hindered understanding of its chemical composition, sources, and toxic effects. In the first steps of a larger study, here, we aimed to elucidate relationships between source regions, ambient conditions, and the chemical composition in water extracts of PM_2.5 samples (n = 85) collected over 16 months at an observatory in the Yellow Sea. In each extract, we quantified elements and major ions and profiled the complex mixtures of organic compounds by nontarget mass spectrometry. More than 50,000 nontarget features were detected, and by consensus of in silico tools, we assigned a molecular formula to 13,907 features. Oxygenated compounds were most prominent, followed by mixed nitrogenated/oxygenated compounds, organic sulfates, and sulfonates. Spectral matching enabled identification or structural annotation of 43 substances, and a workflow involving SIRIUS and MS-DIAL software enabled annotation of 74 unknown per- and polyfluoroalkyl substances with primary source regions in China and the Korean Peninsula. Multivariate modeling revealed seasonal variations in chemistry, attributable to the combination of warmer temperatures and maritime source regions in summer and to cooler temperatures and source regions of China in winter.

Molecularly imprinted polymers (MIPs) have proven to be particularly effective chemical probes for the molecular recognition of proteins, DNA, and viruses. Here, we started from a filamentous bacteriophage to synthesize a multi-functionalized MIP for detecting the acidic pharmaceutic clofibric acid (CA) as a chemical pollutant. Adsorption and quartz crystal microbalance with dissipation monitoring experiments showed that the phage-functionalized MIP had a good binding affinity for CA, compared with the non-imprinted polymer and MIP. In addition, the reusability of the phage-functionalized MIP was demonstrated for at least five repeated cycles, without significant loss in the binding activity. The results indicate that the exposed amino acids of the phage, together with the polymer matrix, create functional binding cavities that provide higher affinity to acidic pharmaceutical compounds.