Based on the nonequilibrium evolution thermodynamics, the structure refinement of metals during severe plastic deformation is investigated. To describe the formation of stationary (limiting) submicrocrystalline or nanocrystalline structures, a two-defect approximation, including the grain boundaries and dislocations, is used. Introduction of the additive noise for the main parameters into the governing equations allowed us to describe the self-consistent behavior of structural defects during the stationary structure formation. Conditions of achieving the stationary state are investigated and possible scenarios of structure refinement modes are determined. Obtained grain boundary density distributions help to estimate the composition of grain structure in the bulk of metal sample quantitatively. The analysis of time evolution of the grain boundaries density shows the presence of correlated fluctuations. The autocorrelation function, describing the frequency characteristics of the structure refinement, is determined.
Background: The frictional properties of nanoparticles have been studied to gain insight into the fundamental origin of sliding friction.Results: Using molecular dynamics we investigate frictional properties of aluminum and palladium nanoparticles deposited on a graphene layer. We study the time evolution of the total momentum of the system, the total and potential energies, the temperature, the velocity and position of the center of mass, the dimensions of the nanoparticle, and the friction and substrate forces acting on the particle. We also study how the friction force depends on the nanoparticle–graphene contact area and the temperature.Conclusion: The tribological properties of nanoparticles strongly depend on the materials. The particles move in an irregular (saw-like) manner. The averaged friction force depends nearly linearly on the contact area and non-monotonously on temperature. We observe ordered crystalline domains of atoms at the bottom surface of the metal particles, but the peaks of radial distribution function are blurred indicating that the nanoparticles are amorphous or polycrystalline.
Using the method of classical molecular dynamics the tribological properties are studied of one molecular layer of liquid carbon disulfide, pressed by two atomically smooth diamond surfaces. We treat the models of elastic spheres for carbon disulfide molecules and absolutely rigid diamond plates. The found time series of atomic level friction force at the contact is heterogeneous. An increase of the external normal pressure leads to the transition of the film to a solidlike state. This is manifested in a decrease of the diffusion constant, in the behavior of velocity autocorrelation function of liquid molecules and average friction force.