Sung Kim

Prof. Dr. Sung Kim

orcid

Research Focus & Metrics

Academic Career Length

19Years (2008-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications

15 June 2018 in Analytical Chemistry
Verified
Journal Article
Closed access
XHXu Han
Xu Han
HKHossein Shokri Kojori
Hossein Shokri Kojori
Roger LeblancRoger Leblanc
Roger Leblanc
SKSung Kim
Sung Kim

20 August 2016 in Materials Letters
Verified
Journal Article
Closed access
YPYoung Hun Paik
Young Hun Paik
HKHossein Shokri Kojori
Hossein Shokri Kojori
JYJu-Hyung Yun
Ju-Hyung Yun
SKSung Kim
Sung Kim

8 September 2016 in Nanoscale
Verified
Journal Article
Closed access
PDF file
HKHossein Shokri Kojori
Hossein Shokri Kojori
YJYiwen Ji
Yiwen Ji
YPYounghun Paik
Younghun Paik
ABAdam B. Braunschweig
Adam B. Braunschweig
SKSung Kim
Sung Kim
By immobilizing glycopolymers onto the surface of the recently developed plasmonic field effect transistor (FET), the recognition between lectins and surface-immobilized glycopolymers can be detected over a wide dynamic range (10−10 to 10−4 M) in an environment that resembles the glycocalyx. The binding to the sensor surface by various lectins was tested, and the selectivities and relative binding affinity trends observed in solution were maintained on the sensor surface, and the significantly higher avidities are attributed to cluster-glycoside effects that occur on the surface. The combination of polymer surface chemistry and optoelectronic output in this device architecture produces amongst the highest reported detection sensitivity for ConA. This work demonstrates the benefits that arise from combining emerging device architectures and soft-matter systems to create cutting edge nanotechnologies that lend themselves to fundamental biological studies and integration into point-of-use diagnostics and sensors.

30 July 2020 in Applied Sciences
Verified
Journal Article
Open access
PDF file
CTChong Tong
Chong Tong
MKManjeet Kumar
Manjeet Kumar
JYJu-Hyung Yun
Ju-Hyung Yun
Joodong KimJoodong Kim
Joodong Kim
SKSung Kim
Sung Kim
A heterostructure of Sn-doped In2O3 (ITO)/Al-doped ZnO (AZO)/n-Si was proposed and studied for photovoltaics. The top ITO worked as a transparent conducting layer for excellent optical transparency and current collection. The AZO/n-Si served as the active junction and provided the built-in potential (qVbi) for the photovoltaic devices. To achieve a higher open circuit voltage (Voc), which is the main challenge for AZO/Si heterojunctions due to the junction interfacial defects, the AZO and AZO/Si junction properties were systematically investigated. By modulating the Al doping in the AZO thin films via a dual beam co-sputtering technique, the AZO/n-Si junction quality was significantly improved with qVbi increased from 0.21 eV to 0.74 eV. As a result, the Voc of our best device was enhanced from 0.14 V to 0.42 V, with a short circuit current (Jsc) of 26.04 mA/cm2 and a conversion efficiency (Eff) of 5.03%. To our best knowledge, this is the highest Voc reported for ZnO/Si heterojunctions prepared by the sputtering method. The results confirmed the validity of our proposed structure and junction engineering approach and provided new insights and opportunities for ZnO/Si heterojunction optoelectronics.

20 January 2016 in Nanotechnology
Verified
Journal Article
Closed access
PDF file
YPYoung Hun Paik
Young Hun Paik
HKHossein Shokri Kojori
Hossein Shokri Kojori
SKSung Kim
Sung Kim
We successfully demonstrate the synthesis of lead zirconate titanate nanoparticles (PZT NPs) and a ferroelectric device using the synthesized PZT NPs. The crystalline structure and the size of the nanocrystals are studied using x-ray diffraction and transmission electron microscopy, respectively. We observe <100 nm of PZT NPs and this result matches dynamic light scattering measurements. A solution-based low-temperature process is used to fabricate PZT NP-based devices on an indium tin oxide substrate. The fabricated ferroelectric devices are characterized using various optical and electrical measurements and we verify ferroelectric properties including ferroelectric hysteresis and the ferroelectric photovoltaic effect. Our approach enables low-temperature solution-based processes that could be used for various applications. To the best of our knowledge, this low-temperature solution processed ferroelectric device using PZT NPs is the first successful demonstration of its kind.