In most cases, conventional drying produces inferior quality products and requires higher drying times. A continuous pilot Refractance Window® equipment was used to dry Aloe vera gel slabs of 5 and 10 mm thick at 60, 70, 80, and 90 °C, seeking a dry product with high-quality retention. Based on five empirical models, drying kinetics, diffusion coefficient, and activation energy were analyzed. Midilli–Kuck was the best predicting model. Short drying times (55–270 min) were needed to reach 0.10 g water/g solid. In addition, the technique yielded samples with high rehydration capacity (24–29 g water/g solid); high retention of color (∆E, 3.74–4.39); relatively low losses of vitamin C (37–59%) and vitamin E (28–37%). Regardless of the condition of temperature and sample thickness, a high-quality dried Aloe vera gel could be obtained. Compared with other methods, Refractance Window® drying of Aloe vera achieved shorter drying times with higher quality retention in terms of color, vitamins C and E, and rehydration. Finally, the dried Aloe vera gel could be reconstituted to a gel close to its fresh state by rehydration.
Colombian mango production, which exceeded 261,000 t in 2020, generates about 40% of the whole fruit as solid waste, of which more than 50% are seed kernels (over 52,000 t solid by-product); though none is currently used for commercial purposes. This study reports the results of the supercritical carbon dioxide (scCO2) extraction of an oil rich in essential fatty acids (EFAs) from revalorized mango seed kernels and the optimization of the process by the Response Surface Methodology (RSM). In pilot-scale scCO2 experiments, pressure (23–37 MPa) and temperature (52–73 °C) were varied, using 4.5 kg of CO2. The highest experimental oil extraction yield was 83 g/kg (37 MPa and 63 °C); while RSM predicted that 84 g/kg would be extracted at 35 MPa and 65 °C. Moreover, by fine-tuning pressure and temperature it was possible to obtain an EFA-rich lipid fraction in linoleic (37 g/kg) and α-linolenic (4 g/kg) acids, along with a high oleic acid content (155 g/kg), by using a relatively low extraction pressure (23 MPa), which makes the process a promising approach for the extraction of oil from mango waste on an industrial scale, based on a circular economy model.
15 July 2022 in International Journal of Food Science
Valorisation of food processing by-products is a welcome and developing area. The mango processing industry produces 40% to 60% of the fruit as solid waste, in which components of industrial interest, such as pectin, are lost. This study reports on energy-efficient high-intensity ultrasound-assisted extraction (HIUAE) to extract pectin from mango peels. The analysis considered the ripening stage of the fruit (0, 2, and 4), HIUAE frequency (37 kHz and 80 kHz), and extraction time (20 min, 25 min, and 30 min). Extractions of pectin from mango peels with HIUAE have been fairly studied. However, this work differs from those studies in including mango maturity grade as a factor. Pectin extraction yields ranged from 13% to 30%, with no influence ( ) of time, and the highest yields were obtained at the lowest maturity stage (0) and lowest frequency (37 kHz). This latest condition (37 kHz) also yielded pectin with the highest gel strength, purity, and quality. This work demonstrated that the mango maturity stage influenced pectin extraction yield. Ultrasound-assisted extraction of pectin from mango peels could be an efficient approach toward waste valorisation and extraction of pectin with high yield and good quality attributes for the food industry.