The majority of articles on Adiabatic Compressed Air Energy Storage (A-CAES) so far have focussed on the use of indirect-contact heat exchangers and a thermal fluid in which to store the compression heat. While packed beds have been suggested, a detailed analysis of A-CAES with packed beds is lacking in the available literature. This paper presents such an analysis. We develop a numerical model of an A-CAES system with packed beds and validate it against analytical solutions. Our results suggest that an efficiency in excess of 70% should be achievable, which is higher than many of the previous estimates for A-CAES systems using indirect-contact heat exchangers. We carry out an exergy analysis for a single charge–storage–discharge cycle to see where the main losses are likely to transpire and we find that the main losses occur in the compressors and expanders (accounting for nearly 20% of the work input) rather than in the packed beds. The system is then simulated for continuous cycling and it is found that the build-up of leftover heat from previous cycles in the packed beds results in higher steady state temperature profiles of the packed beds. This leads to a small reduction (<0.5%) in efficiency for continuous operation
Solar energy use in the UK is increasing dramatically, providing both heat energy and generation of electricity. This trend is expected to continue due to solar technologies becoming cheaper and more readily available along with low carbon government legislation such as the Renewable Heat Incentive (RHI) and Feed in Tariffs (FiTs) supporting solar energy deployment. However, the effects of climate change on the solar resource remain largely unstudied. Climate change affects cloud cover characteristics and consequently directly affects the performance of solar energy technologies.This paper investigates the UK solar irradiation resource for both the present and future climates.The present solar irradiation level was assessed through the conversion of 30 years of observed historical monthly average sunshine duration data. The method and results are validated by comparing the converted solar irradiation levels to actual solar irradiance measurements at weather stations with significant historical records of solar irradiance data.The impact of climate change is investigated across different regions of the UK by using the UKCP09 probabilistic climate change projections.We find that the current average UK annual solar resource is 101.2 Wm−2, ranging from 128.4 Wm−2 in the south of England to 71.8 Wm−2 in the northwest of Scotland. It seems likely that climate change will increase the average resource in the south of the UK, while marginally decreasing it in the Northwest. The overall effect is a mean increase of the UK solar resource, however it will have greater seasonal variability and discrepancies between geographical regions will be reinforced
Accurate occupancy is crucial for planning for sustainable buildings. Using massive, passively-collected mobile phone data, we introduce a novel framework to estimate building occupancy at unprecedented scale. We show that, at urban-scale, occupancy differs widely from current estimates based on building types. For commercial buildings, we find typical occupancy rates are 5 times lower than current assumptions imply, while for residential buildings occupancy rates vary widely by neighborhood. Our mobile phone based occupancy estimates are integrated with a state-of-the-art urban building energy model to understand their impact on energy use predictions. Depending on the assumed relationship between occupancy and internal building loads, we find energy consumption which differs by +1% to −15% for residential buildings and by −4% to −21% for commercial buildings, compared to standard methods. This highlights a need for new occupancy-to-load models which can be applied at urban-scale to the diverse set of city building types.
1 September 2019 in Renewable and Sustainable Energy Reviews