Aircraft and engine technology have continuously evolved since their introduction and significant improvement has been made in fuel efficiency, emissions, and noise reduction. One of the major issues that the aviation industry is facing today is pollution around the airports, which has an effect both on human health and on the climate. Although noise emissions do not have a direct impact on climate, variations in departure and arrival procedures influence both CO₂ and non-CO₂ emissions. In addition, design choices made to curb noise might increase CO₂ and vice versa. Thus, multidisciplinary modeling is required for the assessment of these interdependencies for new aircraft and flight procedures. A particular aspect that has received little attention is the quantification of the extent to which early design choices influence the trades of CO₂, NOx, and noise. In this study, a single aisle thrust class turbofan engine is optimized for minimum installed SFC (Specific Fuel Consumption). The installed SFC metric includes the effect of engine nacelle drag and engine weight. Close to optimal cycles are then studied to establish how variation in engine cycle parameters trade with noise certification and LTO (Landing and Take-Off) emissions. It is demonstrated that around the optimum a relatively large variation in cycle parameters is allowed with only a modest effect on the installed SFC metric. This freedom in choosing cycle parameters allows the designer to trade noise and emissions. Around the optimal point of a state-of-the-art single aisle thrust class propulsion system, a 1.7 dB reduction in cumulative noise and a 12% reduction in EINOx could be accomplished with a 0.5% penalty in installed SFC.

An open-source simulation model for aircraft noise prediction is presented and validated using backpropagated noise measurements for a state-of-the-art engine and aircraft. The validation is focused on approach procedures and was performed using ground-based noise measurements that were taken at 17 recording stations for a total of 18 consecutive flights carried out during the morning of 8 April 2021. The flights were performed using two A321neo aircraft with LEAP-1A engines. It is demonstrated that the presented noise model provides a satisfactory estimation of the source noise for varying approach configurations and flight conditions. Configurations using a greater number of high-lift devices are particularly well predicted in the mid- and high-frequency regions, whereas the lower configuration settings show greater spectral deviations, which are partly attributed to measurement uncertainties caused by the increased aircraft–microphone distance. The model can predict the overall mean total sound intensity level within a 2 dB accuracy for all configurations, while the average predicted level at each microphone differs by less than 3 dB from the measurement average, for all cases except one. Variation in aircraft speed showed to have a strong impact on the predicted total noise, which matches the well-recognized sixth-power Mach number far-field sound intensity scaling law for airframe noise models, while the measurements indicated a less significant dependency. This is mainly due to installation effects and noise reduction measures that are not included in the models. Nevertheless, the variations in the spectra of the predicted and measured noise showed similar patterns.