The present investigation was aimed at elucidating solid particle behaviour in a new design COREX shaft furnace using a new technique called areal gas distribution (AGD). The measurement of solid flow profile was performed with a semi-cylindrical model. To guarantee similarity of conditions, a modified Froude number was taken into consideration in the physical model constructed. The solid flow characteristics in this new furnace with different blast volumes were analysed, and the effect of discharge rate as well as abnormal conditions on solid flow behaviour have also been investigated. The work reveals that solid flow profile in the shaft furnace model progresses through a Flat→Wave→W shape profile as the burden descends. Blast volume has little influence on solid particle behaviour. However, increasing the discharge rate has an effect of decreasing the quasi-stagnant zone size and with the increasing discharge rate, the cross-section of AGD channel increases. For asymmetric flow, particles descend from the top and move to the discharging outlet and a very big stagnant zone is formed on the opposite side of the discharging outlet.
A mathematic model considering the bubble coalescence and breakup using the Euler-Lagrange approach has been developed to study the effect of the initial bubble size on the distribution of bubbles captured by the solidification shell. A hard sphere model was applied for dealing with the bubble collision. Advanced bubble coalescence and breakup models suitable for the continuous casting system and an advanced bubble captured criteria have been identified established with the help of user-defined functions of FLUENT. The predictions of bubble behavior and captured bubble distribution agree with the water model and plant measurements well respectively. The results show that the number of small bubbles captured by solidification shell is much higher than that of large bubbles. What is more, the number of captured bubbles at the sidewalls decreases with the distance from the meniscus. For the case of large gas flow rate (gas flow fraction of 8.2%), the initial size of bubbles has little effect on bubble captured distribution under various casting speeds. When the gas flow rate is small (gas flow fraction of 4.1%), the number density of captured bubbles increases as the initial bubble size increases, and the effect of initial bubbles size on captured bubble number density is amplified when the casting speed decreases. The average captured bubble diameter is about 0.12–0.14 mm. Additionally, for all cases, the initial bubble size hardly affects the average size of captured bubbles.