Background: Dental procedures often produce aerosol and splatter which have the potential to transmit pathogens such as SARS‐CoV‐2. The existing literature is limited.Objective(s): To develop a robust, reliable and valid methodology to evaluate distribution and persistence of dental aerosol and splatter, including the evaluation of clinical procedures.Methods: Fluorescein was introduced into the irrigation reservoirs of a high‐speed air‐turbine, ultrasonic scaler and 3‐in‐1 spray, and procedures were performed on a mannequin in triplicate. Filter papers were placed in the immediate environment. The impact of dental suction and assistant presence were also evaluated. Samples were analysed using photographic image analysis and spectrofluorometric analysis. Descriptive statistics were calculated and Pearson's correlation for comparison of analytic methods.Results: All procedures were aerosol and splatter generating. Contamination was highest closest to the source, remaining high to 1‐1.5 m. Contamination was detectable at the maximum distance measured (4 m) for high‐speed air‐turbine with maximum relative fluorescence units (RFU) being: 46,091 at 0.5 m, 3,541 at 1.0 m and 1,695 at 4 m. There was uneven spatial distribution with highest levels of contamination opposite the operator. Very low levels of contamination (≤0.1% of original) were detected at 30 and 60 minutes post‐procedure. Suction reduced contamination by 67‐75% at 0.5‐1.5 m. Mannequin and operator were heavily contaminated. The two analytic methods showed good correlation (r = 0.930, n = 244, P < .001).Conclusion: Dental procedures have potential to deposit aerosol and splatter at some distance from the source, being effectively cleared by 30 minutes in our setting.
To determine the radiographic position and reliability of assessing mental foramen (MF) position in relation to premolar crowns in an 18- to 30-year-old UK-based population. Following ethical approval and a power calculation, the position of the MF was recorded in relation to premolar crowns and apices in 100 dental panoramic tomographs. Positions were assessed by three senior clinicians independently, then by consensus. Data were analysed using descriptive statistics, χ2 and Fleiss' and Cohen's kappa. Reliability data showed only fair to moderate agreement on independent scoring. Substantial to almost perfect agreement was achieved by consensus, demonstrating the most common position for the MF to be between the first and second premolar teeth when using both premolar crowns (51%) and apices (76%) as reference points. There was a significant difference in the position of the foramen between the left and right sides (p < 0.05), with only 62% of cases showing symmetry. The most common position for the MF is between the first and second premolar teeth; however, anatomical variation is seen. Use of pre-operative radiographs to relate the position of the MF to premolar crowns may not be reliable.