Low-temperature solid oxide fuel cells permit the possibility of metallic interconnects over conventional ceramic interconnects. Among various metallic interconnects, the ferritic interconnects are the most promising. However, chromium poisoning in them adversely affects their performance. To resolve this issue, various coatings and pretreatment methods have been studied. Herein, this article encloses the coating of CuFe2O4 spinel over two prominent ferritic interconnects (Crofer 22 APU and SUS 430). The CuFe2O4 spinel layer coating has been developed by the dip-coating of both samples in CuFe2O4 slurry, followed by heat treatment at 800 °C in a reducing environment (5% hydrogen and 95% nitrogen). Additionally, both samples were annealed to further enhance their spinel coating structure. The morphological and crystallinity analysis confirmed that the spinel coating formed multiple layers of protection while annealing further reduced the thickness and improved the densities. Moreover, the area-specific resistance (ASR) and weight gain rate (WGR) of both samples before and after annealing was calculated using mathematical modeling, which matches with the experimental data. It has been noted that CuFe2O4 spinel coating improved the ASR and WGR of both samples which were further improved after annealing. This research reveals that the CuFe2O4 spinel is the promising protective layer for ferritic interconnects and annealing is the better processing technique for achieving the preferred properties.
Low-temperature solid oxide fuel cells revitalizing usage of metallic interconnects over former ceramic materials. However, chromium poisoning is reducing the performance of ferritic interconnects. To resolve this problem, an attempt to layer metal-oxide coating has been considered. This article encloses the fabrication of optimized slurry composition of CuFe2O4 spinel over Crofer 22 APU and SUS 430 by using the dip-coating technique. These coated samples were dried, heated at 800oC in reducing environment (5% hydrogen and 95% nitrogen), oxidized in the open air and lastly annealed. SEM-EDS results are confirming that spinel protection layer has been fabricated over steel substrates, avoiding any spallation. Annealing reduced thickness of oxide layer from 7.25µm to 4.69µm and improved density of spinel. Spinel coated Crofer 22 APU and SUS 430 formed three and four layers with weight gain rate of 1.65 x 10-12 g2 cm-4.s-1 and 2.597 x 10-12 g2cm-4.s-1 respectively. Decarburization was also observed in both substrates during operational heating and annealing process. The research reveals that the spinel is the promising protective layer for interconnects of SOFC and annealing is the better processing technique for achieving the preferred properties.
Hot rolling and heat treatment are the two industrial metallurgical applications used with compatible steels to modify mechanical properties. In this article, we studied the combined effect of hot rolling and heat treatment at constant parameters on medium carbon steels with respect to reduced thickness. For this purpose, the precasted round billets (110-mm diameter) of AISI-1045 and the square billet (110 by 110 mm) of JIS-SUP 9 were hot rolled and the thickness was reduced up to 6, 8, and 12 mm and 18, 28, and 45 mm, respectively. The hot rolled billets were subjected to heat treatment. The chemical compositions of the steels were evaluated by optical emission spectroscopy, whereas the microstructures of the samples after hot rolling and heat treatment were observed through metallography. Furthermore, the mechanical properties of the samples were calculated through the tensile test. The results showed a fall in ductility and toughness with respect to reduced thickness and a rise in mechanical strength. It is noteworthy that breaking strength remained unaffected. The JIS-SUP 9 steel is a spring steel, which is the reason for its better mechanical properties (e.g., toughness and ductility) as compared with AISI-1045 steel.