Kwang Soo Yoo

Prof. Kwang Soo Yoo


Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 June 2015 in Sensors
Verified
Journal Article
Open access
PDF file
KYKwang Soo Yoo
Kwang Soo Yoo
SHSoodeok Han
Soodeok Han
HMHi Gyu Moon
Hi Gyu Moon
SYSeok-Jin Yoon
Seok-Jin Yoon
CKChong-Yun Kang
Chong-Yun Kang
As highly sensitive H2S gas sensors, Au- and Ag-catalyzed SnO2 thin films with morphology-controlled nanostructures were fabricated by using e-beam evaporation in combination with the glancing angle deposition (GAD) technique. After annealing at 500 °C for 40 h, the sensors showed a polycrystalline phase with a porous, tilted columnar nanostructure. The gas sensitivities (S = Rgas/Rair) of Au and Ag-catalyzed SnO2 sensors fabricated by the GAD process were 0.009 and 0.015, respectively, under 5 ppm H2S at 300 °C, and the 90% response time was approximately 5 s. These sensors showed excellent sensitivities compared with the SnO2 thin film sensors that were deposited normally (glancing angle = 0°, S = 0.48).

6 November 2017 in Materials
Verified
Journal Article
Open access
PDF file
KYKwang Soo Yoo
Kwang Soo Yoo
YKYeon Hui Kang
Yeon Hui Kang
KIKyoung Ran Im
Kyoung Ran Im
CKChang-Sam Kim
Chang-Sam Kim
Al2O3-coated Li(Ni0.6Co0.2Mn0.2)O2 cathode materials were prepared by simple surface modification in water media through a sol-gel process with a dispersant. The crystallinity and surface morphology of the samples were characterized through X-ray diffraction analysis and scanning electron microscopy observation. The Li(Ni0.6Co0.2Mn0.2)O2 cathode material was of a polycrystalline hexagonal structure and agglomerated with particles of approximately 0.3 to 0.8 μm in diameter. The nanosized Al2O3 particles of low concentration (0.06–0.12 wt %) were uniformly coated on the surface of Li(Ni0.6Co0.2Mn0.2)O2. Measurement of electrochemical properties showed that Li(Ni0.6Co0.2Mn0.2)O2 coated with Al2O3 of 0.08 wt % had a high initial discharge capacity of 206.9 mAh/g at a rate of 0.05 C over 3.0–4.5 V and high capacity retention of 94.5% at 0.5 C after 30 cycles (cf. uncoated sample: 206.1 mAh/g and 90.8%, respectively). The rate capability of this material was also improved, i.e., it showed a high discharge capacity of 166.3 mAh/g after 5 cycles at a rate of 2 C, whereas the uncoated sample showed 155.8 mAh/g under the same experimental conditions.

1 December 2006 in Journal of Electroceramics
Verified
Journal Article
Closed access
PDF file
HSHan Byel Shim
Han Byel Shim
JKJu Hyun Kang
Ju Hyun Kang
JCJung Woon Choi
Jung Woon Choi
KYKwang Soo Yoo
Kwang Soo Yoo

31 July 2013 in Journal of Sensor Science and Technology
Verified
Journal Article
Closed access
WCWoo-Sung Choi
Woo-Sung Choi
MKMin Gyu Kang
Min Gyu Kang
YDYoung-Ho Do
Young-Ho Do
WJWoo-Suk Jung
Woo-Suk Jung
BJByeong-Kwon Ju
Byeong-Kwon Ju
CKChong-Yun Kang
Chong-Yun Kang