Beijing Key Laboratory of Network System Architecture and Convergence, Beijing Laboratory of Advanced Information Network, Beijing University of Posts and Telecommunications, Beijing, China
Dr. Liang Yin
Beijing Key Laboratory of Network System Architecture and Convergence, Beijing Laboratory of Advanced Information Network, Beijing University of Posts and Telecommunications, Beijing, China
This letter proposes a novel interference mitigation technique for spectral coexistence between large-scale non-geostationary orbit (NGSO) satellite systems by optimizing satellite antenna beam pointing. Firstly, a dynamic exclusion zone of NGSO satellite antenna beam pointing is defined. Secondly, we transfer frequency compatibility problem between NGSO systems into a constrained nonlinear multivariate optimization problem considering the joint effect of link distances as well as angles between links and solve it using Genetic Algorithm (GA). Then we select actual working parameters of Starlink and OneWeb satellite systems to verify the effectiveness of proposed interference mitigation technique in the worldwide. The available time of the interfered system is up to 98.5% of total simulation run time after interference mitigation. The results show that the proposed interference mitigation technique can effectively mitigate the interference between NGSO satellite systems and guarantee signal to interference plus noise ratio (SINR) at the interfered earth station.
It is inevitable that high-intensity, wide-spectrum electromagnetic emissions are generated by the power electronic equipment of the Extra High Voltage (EHV) power converter station. The surveillance flight of Unmanned Aerial Vehicles (UAVs) is thus, situated in a complex electromagnetic environment. The ubiquitous electromagnetic interference demands higher electromagnetic protection requirements from the UAV construction and operation. This article is related to the UAVs patrol inspections of the power line in the vicinity of the EHV converter station. The article analyzes the electromagnetic interference characteristics of the converter station equipment in the surrounding space and the impact of the electromagnetic emission on the communication circuits of the UAV. The anti-electromagnetic interference countermeasures strive to eliminate or reduce the threats of electromagnetic emissions on the UAV’s hardware and its communication network.
20 January 2023 in IEEE Transactions on Antennas and Propagation
Angular momentum (AM) multiplexing technique provides multiple information channels for electromagnetic waves (EMWs) modulation at the same frequency, improving spectrum efficiency effectively. Among AM multiplexing techniques, the patch antenna has the advantage of minimization, simple feeding circuits, and easy integration. Nevertheless, limited reports provide theoretical guidance for designing AM multiplexing patch antennas. Herein, we propose a scheme to achieve AM multiplexing via a shared-aperture patch antenna. The radiating structure consists of multiple radiating patches sharing a common physical aperture, each of which is responsible for producing different AM-carrying waves. By analyzing the theoretical model built on a dipole representation of the patch antenna, the shapes and the desired current patterns of these patches can be determined according to the AM mode of the expected EMWs. Besides, the sizes and feeding structures of these patches can be studied by investigating their radiating characteristics using characteristic mode (CM) theory. For proof-of-concept, a prototype was designed, fabricated, and measured for the generation of four orthogonal AM-carrying waves coaxially at 5.8GHz. The experimental results agree reasonably well with the simulated ones, demonstrating that the proposed scheme provides an efficient guidance for the design of AM multiplexing patch antennas.
29 March 2018 in IEEE Transactions on Electromagnetic Compatibility
Cochannel pulse radar and long term evolution (LTE) deployments are considered by the FCC citizen broadband radio service (CBRS) and also 5G spectrum sharing. This paper proposes a radar spectrum sharing method based on LTE reduced-power almost blank subframe (RP-ABS) mechanism, which is used to mitigate interference to pulse radar while maintaining high LTE throughput. For LTE, payload bits are first packed into nonradar interfered time domain subframes (SFs), and then RP-ABS or even zero-power almost blank subframe (ABS) are adopted in the rest SFs. For pulse radar, target detection performance is guaranteed, thanks to the decreased interference caused by LTE RP-ABS power. We also formulate and solve an optimization problem for radar and RP-ABS-based LTE spectrum sharing, which consider tradeoffs between RP-ABS-based LTE performance (bit error rate and throughput) and radar detection probability concurrently. Using 3rd generation partnership project (3GPP) LTE sensitivity test as a benchmark, 28.83% throughput gain can be obtained for RP-ABS-based method. A hardware-in-the-loop testbed is also designed to prove spectrum sharing between RP-ABS-based LTE and radar viable.
30 June 2012 in The Journal of China Universities of Posts and Telecommunications
Millimeter wave, especially the high frequency millimeter wave near 100 GHz, is one of the key spectrum resources for the sixth generation (6G) mobile communication, which can be used for precise positioning, imaging and large capacity data transmission. Therefore, high frequency millimeter wave channel sounding is the first step to better understand 6G signal propagation. Because indoor wireless deployment is critical to 6G and different scenes classification can make future radio network optimization easy, we built a 6G indoor millimeter wave channel sounding system using just commercial instruments based on time-domain correlation method. Taking transmission and reception of a typical 93 GHz millimeter wave signal in the W-band as an example, four indoor millimeter wave communication scenes were modeled. Furthermore, we proposed a data-driven supervised machine learning method to extract fingerprint features from different scenes. Then we trained the scene classification model based on these features. Baseband data from receiver was transformed to channel Power Delay Profile (PDP), and then six fingerprint features were extracted for each scene. The decision tree, Support Vector Machine (SVM) and the optimal bagging channel scene classification algorithms were used to train machine learning model, with test accuracies of 94.3%, 86.4% and 96.5% respectively. The results show that the channel fingerprint classification model trained by machine learning method is effective. This method can be used in 6G channel sounding and scene classification to THz in the future.