Lubrication is an essential factor in the metal forming processes such as forging, since it leads to reducing friction at contact surfaces and increasing the surface quality of the forged parts. In order to create desirable tribological properties in the base lubricants, various metal oxide nanoparticles are mostly used as additives. In the present study, the effects of the nanolubricants made by copper oxide (CuO) and alumina (AL2O3) nanoparticles on the surface quality of the forging process have been investigated. The effects of the nanolubricants have been compared with the graphite as a conventional lubricant. Upsetting forging operation of a ring shape workpiece was used for evaluating the lubricants. Experiments were designed and analyzed using Taguchi method and analysis of variance. Results show that the nanolubricants cause a significant improvement on the surface roughness compared to conventional lubricants. Best condition is obtained when 0.8 wt% of CuO nanoparticles is added in paraffin lubricant. Compared with the case of base lubricants with no additives, roughness reduced by 41% and 33% for paraffin and oil10, respectively. Also, the surface roughness decreased by 496% and 235% compared with dry graphite powder and paraffin with 25% graphite, correspondingly.
19 November 2018 in Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology
Due to lower environmental pollution and also higher biodegradability of vegetable base oils relative to mineral base oils, they can be a good alternative for mineral base types in the metal forming industry. The aim of this study was to evaluate the lubrication efficiency of vegetable base oils relative to mineral base oils (SAE 10 W oil) and, if possible, to replace them with mineral base oils in forging. For the extraction of shear friction coefficient, the friction calibration curves have been used by implementing ring compression tests. In order to evaluate the performance of vegetable base oils and do comparison with mineral base oils, surface roughness, friction coefficient and pressing forces have been extracted for both conditions. Experimental works were carried out using a hydraulic press putting pressure on ring-shaped specimens of 2024 aluminum alloy at room temperature. The results of the experimental studies showed that the vegetable base oils had a satisfactory lubrication performance relative to the mineral base oil (SAE 10 W oil). It was inferred that vegetable base lubricants especially walnut oil, leads to 22% reduction of friction coefficient and also it yields to much lower forming forces compared with mineral base lubricants. Moreover, using vegetable base oils leads to more perseverance of the initial surfaces quality about 26% and 37% relative to the mineral base lubricant and the dry status (no lubrication), respectively.