The effectiveness of rear-flow-controlled mist chemical vapor deposition (mist CVD) for the growth of 2-inch α-Ga2O3 epilayers was studied. The numerical simulation indicated that the low velocity of the flow is appropriate for inducing an upward flow on the growth front without a vortex. Under the flow velocity of 0.08 m/s, α-Ga2O3 the epilayers were successfully grown on c-plane sapphire substrates. The epilayers were high-quality with full widths at half maximum of 42 arcsec and 1993 arcsec for the (0006) and (104) plane reflections, respectively. The rear-flow-controlled mist CVD was demonstrated to be effective for long-time growth. The thickness was adequately increased with increasing growth time. At the same time, corundum α-phase crystal features were distinguished. The suggested mist CVD system not only provides a cost-saving solution for Ga2O3 epilayers’ growth but is also effective for retaining the uniformity of the Ga2O3 epilayers over a large area.
We report the selective-area growth of a gallium nitride (GaN)-nanorod-based InGaN/GaN multiple-quantum-well (MQW) core-shell structure embedded in a three-dimensional (3D) light-emitting diode (LED) grown by metalorganic chemical vapor deposition (MOCVD) and its optical analysis. High-resolution transmission electron microscopy (HR-TEM) observation revealed the high quality of the GaN nanorods and the position dependence of the structural properties of the InGaN/GaN MQWs on multiple facets. The excitation and temperature dependences of photoluminescence (PL) revealed the m-plane emission behaviors of the InGaN/GaN core-shell nanorods. The electroluminescence (EL) of the InGaN/GaN core-shell-nanorod-embedded 3D LED changed color from green to blue with increasing injection current. This phenomenon was mainly due to the energy gradient and deep localization of the indium in the selectively grown InGaN/GaN core-shell MQWs on the 3D architecture.
Precisely controlled morphology of GaN nanorods was obtained on a thin AlN seed layer and their height increased as the diameter of the mask openings decreased.
α–Ga2O3 thin films were grown on a c–plane sapphire substrate by mist chemical vapor deposition in a horizontal furnace. The microstructure of the α–Ga2O3 grown layers was confirmed by X-ray diffraction. The effects of the temperature distribution and velocity field of the mist flow at the surface of the substrate on the uniformity of the epitaxy layers were revealed by numerical simulations and experimental measurements. The thickness uniformity of the thin film was found to be dependent on the position of the inlet and on the flow rate. The suggested configuration for obtaining highly uniform Ga2O3 epilayers is a low flow rate of less than 0.1 m/s and the flow directed from the bottom of the substrate to the top surface of the substrate.