The regularities of the ultrafine-grained structure formation in the binary TiNi-based alloy under stepwise warm (673–573 K) abc pressing are presented. The appearance of a mixed type microstructure based on the submicrocrystalline and nanograined components is established. The preferential formation of nanograins inside the volumes of microbands of localized deformation is observed. The phase composition and martensitic transformations at 295 K in the titanium nickelide samples produced by the warm abc pressing are studied.
1 March 2015 in Inorganic Materials: Applied Research
The article discusses investigations into evolution of microstructure and variation of temperatures of martensitic transformations of the alloy Ti49.8Ni50.2 (at %) with increase in the degree of deformation under isothermal abc pressing (T = 723 K). It is discovered that, at the initial stages of the abc pressing in the vicinity of forge cross, the grain size sharply decreases; in some cases, this decrease exceeds the initial size by about an order of magnitude. Possible mechanisms of formation of such structure are analyzed. It has been demonstrated that, at the degrees of true deformation e > 2, the grain structure in total specimen bulk is refined through the mechanism of continuous dynamic recrystallization, which leads to formation of a homogeneous fine grain structure with a high volumetric portion of submicrocrystalline and nanostructured fractions. It is established that, at all considered degrees of deformation, the temperatures of martensitic transformations remain actually constant, which can be attributed to intense behavior of dynamic and postdynamic recovery, as well as formation of the martensite phase upon cooling from the pressing temperature.
The paper studies the influence of chemical and phase compositions of NiTi surface layers modified with Si ions by plasma immersion implantation on their interaction with endothelial cells. It is shown that certain technological modes of Si ion implantation enhance the adhesion, proliferation, and viability of endothelial cells. It is found that the Si-modified NiTi surface is capable of stimulating the formation of capillary-like structures in the cell culture.
The paper reports on a study of NiTi-based alloys used for manufacturing self-expanding intravascular stents to elucidate how the technological modes of plasma immersion ion implantation with silicon influence the chemical and phase composition of their surface layers. It is shown that two types of surface structure can be obtained depending on the mode of plasma immersion implantation: quasi-amorphous Si coating and Si-doped surface layer. The Si-doped surface layer contains new phases: a phase structured as the main B2 phase of NiTi but with a lower lattice parameter, R phase, and phase of highly dispersed SiO2 precipitates.
In search for a drug-containing material when creating polymer-free drug-eluting stents, an analysis of the available literature is carried out. It is shown that one of the promising materials for this purpose is mesoporous silicon (the cross-sectional pore diameter is 2–50 nm), which has high biocompatibility and biodegradability. The main requirements for the porous silicon coating as a drug carrier of metal intravascular stents are formulated. The results of experimental studies are presented, including those performed by the authors, showing the possibility of continuous silicon coating application up to 0.6 μm thick on the stents by magnetron sputtering or plasma-immersion ion implantation and deposition (PIII@D). These methods provide high coating adhesion to the stent material and allow coating both on the external and internal stent surfaces.