Though commonly used to calculate Q-factor and fractional bandwidth, the energy stored by radiating systems (antennas) is a subtle and challenging concept that has perplexed researchers for over half a century. Here, the obstacles in defining and calculating stored energy in general electromagnetic systems are presented from first principles as well as using demonstrative examples from electrostatics, circuits, and radiating systems. Along the way, the concept of unobservable energy is introduced to formalize such challenges. Existing methods of defining stored energy in radiating systems are then reviewed in a framework based on technical commonalities rather than chronological order. Equivalences between some methods under common assumptions are highlighted, along with the strengths, weaknesses, and unique applications of certain techniques. Numerical examples are provided to compare the relative margin between methods on several radiating structures.
13 October 2016 in IEEE Antennas and Propagation Magazine
This article describes a body area network (BAN) for measuring an electrocardiogram (ECG) signal and transmitting it to a smartphone via Bluetooth for data analysis. The BAN uses a specially designed planar inverted F-antenna (PIFA) with a small form factor, realizable with low-fabricationcost techniques. Furthermore, due to the human body's electrical properties, the antenna was designed to enable surface-wave propagation around the body. The system utilizes the user's own smartphone for data processing, and the built-in communications can be used to raise an alarm if a heart attack is detected. This is managed by an application for Android smartphones that has been developed for this system. The good functionality of the system was confirmed in three real-life user case scenarios.
13 November 2017 in IEEE Antennas and Wireless Propagation Letters
Antenna current optimization is often used to analyze the optimal performance of antennas. Antenna performance can be quantified in e.g., minimum Q-factor and radiation efficiency. The performance of MIMO antennas is more involved and, in general, a single parameter is not sufficient to quantify it. Here, the capacity of an idealized channel is used as the main performance quantity. An optimization problem in the current distribution for optimal capacity, measured in spectral efficiency, given a fixed Q-factor and radiation efficiency is formulated as a semi-definite optimization problem. A model order reduction based on characteristic and energy modes is employed to improve the computational efficiency. The performance bound is illustrated by solving the optimization problem numerically for rectangular plates and spherical shells.
28 June 2019 in IEEE Antennas and Propagation Magazine
The optimal spectral efficiency and the number of independent channels for multiple-input-multiple-output (MIMO) antennas in isotropic multipath channels are investigated when bandwidth requirements are placed on the antenna. By posing the problem as a convex optimization problem restricted by the port Q-factor, a semianalytical expression is formed for its solution. The antennas are simulated by method of moments, and the solution is formulated both for structures fed by discrete ports and for design regions characterized by an equivalent current. It is shown that the solution is solely dependent on the eigenvalues of the so-called energy modes of the antenna. The magnitude of these eigenvalues is analyzed for a linear dipole array and a plate with embedded antenna regions. The energy modes are also compared to the characteristic modes to validate characteristic modes as a design strategy for MIMO antennas. The antenna performance is illustrated through spectral efficiency over the Q-factor, a quantity that is connected to the capacity. It is proposed that the number of energy modes below a given Q-factor can be used to estimate the degrees of freedom for that Q-factor.
13 February 2020 in IEEE Transactions on Antennas and Propagation
Modern antenna design for communication systems revolves around two extremes: devices, where only a small region is dedicated to antenna design, and base stations, where design space is not shared with other components. Both imply different restrictions on what performance is realizable. In this paper a computationally efficient method for calculating the fundamental performance bound on spectral efficiency is presented. The performance bound is calculated for MIMO antennas with a radiation efficiency requirement. A convex optimization problem is formulated in the current density of the antenna, this problem is solved by constructing its dual problem. The solution to this problem is based on a set of modes known as the radiation modes. This paper shows how to perform modal analysis using these modes to evaluate design strategies for maximal spectral efficiency. This is illustrated both for electrically small, and large, structures. For electrically small structures, sub regions for antenna design are evaluated and analyzed. These are compared to N-degree MIMO systems. For electrically large structures the degrees of freedom per unit area of different shapes are analyzed using radiation modes.