Because the surface-to-volume ratio of quasi-two-dimensional materials is extremely high, understanding their surface characteristics is crucial for practically controlling their intrinsic properties and fabricating p-type and n-type layered semiconductors. Van der Waals crystals are expected to have an inert surface because of the absence of dangling bonds. However, here we show that the surface of high-quality synthesized molybdenum disulfide (MoS2) is a major n-doping source. The surface electron concentration of MoS2is nearly four orders of magnitude higher than that of its inner bulk. Substantial thickness-dependent conductivity in MoS2nanoflakes was observed. The transfer length method suggested the current transport in MoS2following a two-dimensional behavior rather than the conventional three-dimensional mode. Scanning tunneling microscopy and angle-resolved photoemission spectroscopy measurements confirmed the presence of surface electron accumulation in this layered material. Notably, the in situ-cleaved surface exhibited a nearly intrinsic state without electron accumulation.
Two-dimensional (2D) semiconducting monolayers such as transition metal dichalcogenides (TMDs) are promising channel materials to extend Moore’s Law in advanced electronics. Synthetic TMD layers from chemical vapor deposition (CVD) are scalable for fabrication but notorious for their high defect densities. Therefore, innovative endeavors on growth reaction to enhance their quality are urgently needed. Here, we report that the hydroxide W species, an extremely pure vapor phase metal precursor form, is very efficient for sulfurization, leading to about one order of magnitude lower defect density compared to those from conventional CVD methods. The field-effect transistor (FET) devices based on the proposed growth reach a peak electron mobility ~200 cm2/Vs (~800 cm2/Vs) at room temperature (15 K), comparable to those from exfoliated flakes. The FET device with a channel length of 100 nm displays a high on-state current of ~400 µA/µm, encouraging the industrialization of 2D materials.
The physical mechanism of the optical transmission of magnetic fluid films under perpendicular magnetic fields is investigated in this work. Under perpendicular magnetic fields, originally dispersed magnetic particles agglomerate to form magnetic columns. The liquid phase is transparent, whereas the columns are opaque. Hence, the liquid phase dominates the optical transmission of the magnetic fluid film. When the field strength is raised, more columns are formed, and the area of the liquid phase is reduced. This leads to the decrease in the optical transmission of the film under higher field strength. The variation in the concentration of the liquid phase under various field strengths also contributes to the transmission of the film. By taking account of the variations of the effective concentration and the area ratio of the liquid phase in the magnetic fluid film under magnetic fields, the resultant magnetic field dependence of the optical transmission was calculated and found to be consistent with the experimental results. This provides evidence for the origin of the field-dependent optical transmission of the magnetic fluid film under external fields.