It is difficult to accurately identify the dynamic deformation of bridges from Global Navigation Satellite System (GNSS) due to the influence of the multipath effect and random errors, etc. To solve this problem, an improved empirical wavelet transform (EWT)-based procedure was proposed to denoise GNSS data and identify the modal parameters of bridge structures. Firstly, the Yule–Walker algorithm-based auto-power spectrum and Fourier spectrum were jointly adopted to segment the frequency bands of structural dynamic response data. Secondly, the improved EWT algorithm was used to decompose and reconstruct the dynamic response data according to a correlation coefficient-based criterion. Finally, Natural Excitation Technique (NExT) and Hilbert Transform (HT) were applied to identify the modal parameters of structures from the decomposed efficient components. Two groups of simulation data were used to validate the feasibility and reliability of the proposed method, which consisted of the vibration responses of a four-storey steel frame model, and the acceleration response data of a suspension bridge. Moreover, field experiments were carried out on the Wilford suspension bridge in Nottingham, UK, with GNSS and an accelerometer. The fundamental frequency (1.6707 Hz), the damping ratio (0.82%), as well as the maximum dynamic displacements (10.10 mm) of the Wilford suspension bridge were detected by using this proposed method from the GNSS measurements, which were consistent with the accelerometer results. In conclusion, the analysis revealed that the improved EWT-based method was capable of accurately identifying the low-order, closely spaced modal parameters of bridge structures under operational conditions.
Monitoring the dynamic responses of bridge structures has received considerable attention. It is important to synchronously measure both the quasi-static and dynamic displacements of bridge structures. However, the traditional accelerometer method cannot capture the quasi-static displacement component, although it can detect the dynamic displacement component. To this end, a novel composite instrument of a smartstation was proposed to monitor vibration displacements of footbridges. Full-scale experiments were conducted on a footbridge to validate the feasibility of the composite instrument-based monitoring method. A Chebyshev filter and wavelet algorithms were developed to process the composite instrument measurements. It was concluded that the measurement noise of the composite instrument was mainly distributed in a frequency range of 0–0.1 Hz. In two case studies with displacement peaks of 5.7–10.0 mm and 1.3– 2.5 mm, the composite instrument accurately identified the quasi-static and dynamic displacements. The composite instrument will be a potential tool for monitoring structural dynamics because of its enhanced overall performance.
30 January 2024 in Measurement Science and Technology
Empirical wavelet transform is often used to process global navigation satellite system (GNSS) bridge deformation monitoring data, but it leads to inaccurate band division and too many spurious modes. To address these problems, this study proposes an improved algorithm to identify bridge modal parameters, which combines improved empirical wavelet transform and robust independent component analysis (ICA). The proposed method adopts the autoregressive power spectrum of an improved covariance algorithm, instead of the Fourier spectrum, for band division. Additionally, it performs noise reduction and reconstruction of multi-channel GNSS monitoring data. The reconstructed signal is inputted as multi-channel observation signal into robust ICA to extract features of the source signal. Finally, the natural excitation technique and Hilbert transform are used to solve the self-oscillation frequency and damping ratio of the structure. The proposed method is validated using both simulation data and the GNSS monitoring data of the Wilford suspension bridge. The results show that the proposed method can effectively reduce the measurement noise and successfully identify the first-order vibration frequencies and damping ratios of bridge. This algorithm can also be applied in the parameter identification of other engineering structures from GNSS data.