Due to the massive multipath effects and non-line-of-sight (NLOS) signal receptions, the accuracy and reliability of GNSS positioning solution can be severely degraded in a highly urbanized area, which has a negative impact on the performance of GNSS/INS integrated navigation. Therefore, this paper proposes a multipath/NLOS detection method based on the K-means clustering algorithm for vehicle GNSS/INS integrated positioning. It comprehensively considers different feature parameters derived from GNSS raw observations, such as the satellite-elevation angle, carrier-to-noise ratio, pseudorange residual, and pseudorange rate consistency to effectively classify GNSS signals. In view of the influence of different GNSS signals on positioning results, the K-means clustering algorithm is exploited to divide the observation data into two main categories: direct signals and indirect signals (including multipath and NLOS signals). Then, the multipath/NLOS signal is separated from the observation data. Finally, this paper uses the measured vehicle GNSS/INS observation data, including offline dataset and online dataset, to verify the accuracy of signal classification based on double-differenced pseudorange positioning. A series of experiments conducted in typical urban scenarios demonstrate that the proposed method could ameliorate the positioning accuracy significantly compared with the conventional GNSS/INS integrated navigation. After excluding GNSS outliers, the positioning accuracy of the offline dataset is improved by 16% and 85% in the horizontal and vertical directions, respectively, and the positioning accuracy of the online dataset is improved by 21% and 41% in the two directions. This method does not rely on external geographic information data and other sensors, which has better practicability and environmental adaptability.

Vehicular positioning in urban environments has become a research hotspot in recent years, and global navigation satellite system/inertial navigation system (GNSS/INS) tightly coupled positioning is a commonly used method. With the broadcast of BDS-3 and Galileo four-frequency signals, the multi-frequency and multi-system tightly coupled positioning method provides more possibilities for vehicular positioning in urban environments. At present, most of the studies on multi-frequency and multi-system mainly focus on static or baseline solutions, and there are few studies on the urban dynamic environment. In this paper, based on the triple-frequency GPS/BDS-2/INS tightly coupled positioning model, the BDS-3 four-frequency observation is introduced to conduct a preliminary study on the performance of GPS/BDS-2/BDS-3/INS tightly coupled positioning. Taking into account the positioning accuracy and calculation efficiency of the tightly coupled positioning, single epoch extra-wide-lane/wide-lane (EWL/WL) observation is used to participate in the modeling of tightly coupled positioning. The EWL/WL ambiguity is solved by the geometry-free (GF) method, in which triple-frequency carrier ambiguity resolution (TCAR) and four-frequency carrier ambiguity resolution (FCAR) are used for triple-frequency and four-frequency observations, respectively. Finally, the positioning performance of the tightly coupled method in this paper is evaluated through vehicular experiment. The experimental results show that in the urban dynamic environment, due to the higher quality of the linear combination of BDS-3 four-frequency, the positioning accuracy of the BDS-3/INS tightly coupled was slightly better than that of the triple-frequency BDS-2/INS. Compared with GPS/BDS-2/INS, the GPS/BDS-2/BDS-3/INS tightly coupled positioning accuracy increased by 29.1% and 58.7% in horizontal and vertical directions, respectively, which can realize decimeter positioning accuracy in urban environments.

Vehicular dynamic positioning based on tightly coupled (TC) Global Navigation Satellite System (GNSS)/Inertial Navigation System (INS) integration in urban areas is due to either low accuracy of pseudorange or poor continuity of carrier phase, resulting in insufficient positioning performance. To enhance the stability while ensuring positioning accuracy, this paper proposed a tightly coupled Beidou Navigation Satellite System (BDS)/INS integration scheme by improving measurement modelling with triple-frequency observations: first, a stepwise single-epoch ambiguity resolution of extra-wide-lane (EWL)/wide-lane (WL) combined observations and then modelling the measurement equation with fixed WL observation instead of conventional pseudorange or carrier phase. Experiments were carried out for verification with data collected in real traffic by a measurement vehicle. The proposed method achieved single-epoch output with an RMS statistical accuracy of decimetre level of 0.152 m horizontally and 0.196 m vertically. The signal outage experiment verified that the proposed algorithm is restoring high-accuracy positioning output in single-epoch once the signal is recaptured. The proposed method obtained a positioning accuracy improvement of 43.6% horizontally and 6.2% vertically in signal outage sections compared to the conventional method. This avoids the multiepoch ambiguity searching to fix with conventional carrier-phase processing, thereby improving the positioning stability.