Hikaru Nakamura

Prof. Hikaru Nakamura


Research Focus & Metrics

Academic Career Length

32Years (1995-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 July 2020 in Cement and Concrete Composites
Verified
Journal Article
Closed access
UFUsman Farooq
Usman Farooq
HNHikaru Nakamura
Hikaru Nakamura
TMTaito Miura
Taito Miura
YYYoshihito Yamamoto
Yoshihito Yamamoto

24 August 2020 in Crystals
Verified
Journal Article
Open access
PDF file
MUHAMMAD SHOAIB KARAMMUHAMMAD SHOAIB KARAM
MUHAMMAD SHOAIB KARAM
YYYoshihito Yamamoto
Yoshihito Yamamoto
HNHikaru Nakamura
Hikaru Nakamura
TMTaito Miura
Taito Miura
An analytical investigation focusing on the concrete damage progress of the PBL shear connector under the influence of various lateral pressures, employing a coupled RBSM and solid FEM model was carried out. The analytical model succeeded in simulating the test shear capacities and the failure modes adequately. The internal failure process was also clarified; the two horizontal cracks occurred near the top of the concrete dowels through the hole of the perforated steel plate, and afterward, the two vertical cracks also initiated and propagated along with the shear surface. In a low lateral pressure case, the shear strength was determined by the vertical cracks propagated along the shear surface. While as the amount of applied lateral pressure increased, the shear strength of the two vertical cracked surfaces was enhanced, and the shear strength of the PBL was characterized by the occurrence of the splitting cracks and caused the splitting failure into the side concrete blocks. Moreover, the combined effects of lateral pressure and hole diameters were also evaluated numerically, and it was found that the increase in shear strength was more in a large diameter case subjected to high lateral pressure because of the wide compressive regions generated around the concrete dowel.

17 May 2022 in Cement and Concrete Composites
Verified
Journal Article
Closed access
ASAtik Sarraz
Atik Sarraz
HNHikaru Nakamura
Hikaru Nakamura
Toshiyuki KanakuboToshiyuki Kanakubo
Toshiyuki Kanakubo
TMTaito Miura
Taito Miura
HKHiroya Kobayashi
Hiroya Kobayashi

1 August 2000 in Psychiatry and Clinical Neurosciences
Verified
Journal Article
Closed access
PDF file
HNHikaru Nakamura
Hikaru Nakamura
MNMasao Nakanishi
Masao Nakanishi
TFToshiaki A. Furukawa
Toshiaki A. Furukawa
THToshihiko Hamanaka
Toshihiko Hamanaka
STShinkan Tokudome
Shinkan Tokudome

21 March 2023 in Cement and Concrete Composites
Verified
Journal Article
Closed access
ASAtik Sarraz
Atik Sarraz
HNHikaru Nakamura
Hikaru Nakamura
TMTaito Miura
Taito Miura

25 April 2020 in Journal of Advanced Concrete Technology
Verified
Journal Article
Open access
PDF file
LFLi Fu
Li Fu
HNHikaru Nakamura
Hikaru Nakamura
YYYoshihito Yamamoto
Yoshihito Yamamoto
TMTaito Miura
Taito Miura
Shear failure after flexural yielding is a typical failure mode for a reinforced concrete (RC) member subject to cyclic load, and it is caused by the phenomenon that the initial shear strength is decreased with the increasing plastic ductility until the shear capacity degrades to be lower than the flexural strength. In this study, the flexure-shear behaviors of a number of RC columns with a relatively wide range of crucial structural factors involving tensile reinforcement ratio, shear reinforcement ratio, shear span-depth ratio (covering deep and slender columns) and axial compression load were simulated by the Three Dimensional Rigid-Body-Spring-Method, and the degradation behaviors of shear strength of all specimens were quantitatively evaluated to comprehend the effect of the structural factors. Moreover, the degradation behaviors of shear strength were decoupled into the degradation behaviors of shear resistance components (beam action, arch action, truss action, concrete contribution for beam action) to clarify the mechanism of shear failure after flexural yielding for the RC columns at various crucial structural factors. Consequently, the effect of crucial structural factors on the degradation behaviors of shear strength and shear resistance components were understood and it was concluded that the stepwise degradation of arch action was the dominant mechanism for the investigated structural factors for the shear failure after flexural yielding of RC column. This paper is an extended version in English from the authors’ previous publication [Nakamura, H., Furuhashi, H., Yamamoto, Y. and Miura, T., (2015). “Evaluation of shear strength degradation of RC member subjected to cyclic loading.” Journal of JSCE E2, 71(1), 48-57. (in Japanese)].