Chenxu Zhang

Dr. Chenxu Zhang

Air Force Medical University

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 May 2018 in Energies
Verified
Journal Article
Open access
PDF file
CZChenxu Zhang
Chenxu Zhang
YZYuming Zhang
Yuming Zhang
HGHui Guo
Hui Guo
QJQubo Jiang
Qubo Jiang
PDPeng Dong
Peng Dong
Chunfu ZhangChunfu Zhang
Chunfu Zhang
In this work, the effects of the SiOx interface layer grown by exposure in air on the performance of planar hybrid n-Si/poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate) (PEDOT:PSS) solar cells are investigated. Compared to the cell with a hydrogen-terminated Si surface, the cell with an oxygen-terminated Si surface reveals improved characteristics in power conversion efficiency, increased from 10.44% to 13.31%. By introducing the SiOx, the wettability of the Si surface can be improved, allowing an effective spread of the PEDOT:PSS solution and thus a good contact between the PEDOT:PSS film and Si. More importantly, it can change the polarity of the Si surface from a negative dipole to a positive dipole, owing to the introduction of the SiOx interface. The Si energy band will bend up and give rise to a favorable band alignment between Si and PEDOT:PSS to promote carrier separation. These results could be potentially employed to further development of this simple, low-cost heterojunction solar cell.

13 June 2017 in International Journal of Photoenergy
Verified
Journal Article
Open access
PDF file
CZChenxu Zhang
Chenxu Zhang
YZYuming Zhang
Yuming Zhang
HGHui Guo
Hui Guo
ZZZeyulin Zhang
Zeyulin Zhang
Chunfu ZhangChunfu Zhang
Chunfu Zhang
A systematical investigation was carried out into the effects of the hole-transporting layer treatment of poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate) (PEDOT:PSS) on the performance of planar hybrid n-Si/PEDOT:PSS solar cells. Triton X-100 and ethylene glycol (EG) were chosen to improve the conductivity and surface morphology of the PEDOT:PSS film. It was found that the annealing temperature has a great influence on the PEDOT:PSS material properties and the corresponding device performance. By optimizing the annealing temperature, the conductivity of the PEDOT:PSS film doped with Triton X-100 and EG could be enhanced by a factor of more than three orders. And the corresponding device also shows record power conversion efficiency as high as 14.5% with an open circuit voltage of 0.627 V, a short circuit current of 32.6 mA/cm2, and a fill factor of 70.7%.