The outstading mechanical properties of bimodal ultrafine eutectic composites (BUECs) containing length scale hierarchy in eutectic structure were demonstrated by using AFM observation of surface topography with quantitative height measurements and were interpreted in light of the details of the deformation mechanisms by three different interface modes. It is possible to develop a novel strain accommodated eutectic structure for triggering three different interface-controlled deformation modes; (I) rotational boundary mode, (II) accumulated interface mode and (III) individual interface mode. A strain accommodated microstructure characterized by the surface topology gives a hint to design a novel ultrafine eutectic alloys with excellent mechanical properties.
10 January 2012 in Metallurgical and Materials Transactions A
In the present study, the microstructural evolution and the modulation of the mechanical properties have been investigated for a Co-Cr-Mo (CCM) ternary eutectic alloy by addition of a small amount of copper (0.5 and 1 at.%). The microstructural observations reveal a distinct dissimilarity in the eutectic structure such as a broken lamellar structure and a well-aligned lamellar structure and an increasing volume fraction of Co lamellae as increasing amount of copper addition. This microstructural evolution leads to improved plasticity from 1% to 10% without the typical tradeoff between the overall strength and compressive plasticity. Moreover, investigation of the fractured samples indicates that the CCMCu alloy exhibits higher plastic deformability and combinatorial mechanisms for improved plastic behavior. The improved plasticity of CCMCu alloys originates from several deformation mechanisms; i) slip, ii) deformation twinning, iii) strain-induced transformation and iv) shear banding. These results reveal that the mechanical properties of eutectic alloys in the Co-Cr-Mo system can be ameliorated by micro-alloying such as Cu addition.
The crystallization behavior of bulk amorphous Ti-Zr-Be-Cu-Ni alloys has been studied by using differential scanning calorimetry (DSC), X-ray diffractometry (XRD) and transmission electron microscopy (TEM). Detailed thermal analysis showed that Ti-Zr-Be-Cu-Ni amorphous alloys with the wide composition range crystallized through two exothermic reactions followed by one endothermic reaction. At first stage, nanometer scale primary icosahedral phase (I-phase) precipitated from an amorphous matrix and then the remaining amorphous phase crystallized into cubic β-Ti(Zr) phase or hexagonal Laves phase depending on the alloy composition. Finally, I- and β-Ti(Zr) phase or I- and Laves phase mixture transformed into the Laves phase by the high-temperature endothermic reaction, indicating that the I-phase is a thermally stable phase at the lower temperature range. Reversible transformation between the I-phase and Laves phase during cyclic heating and cooling confirmed the thermodynamic stability of the I-phase in Ti-Zr-Be-Cu-Ni system.