Given the prejudicial environmental effects of fossil-fuel based energy production, renewable energy sources can contribute significantly to the sustainability of human society. As a clean, cost effective and inexhaustible renewable energy source, wind energy harvesting has found a wide application to replace conventional energy productions. However, concerns have been raised over the noise generated by turbine operating, which is helpful in fault diagnose but primarily identified for its adverse effects on the local ecosystems. Therefore, noise monitoring and separation is essential in wind turbine deployment. Recent developments in condition monitoring provide a solution for turbine noise and vibration analysis. However, the major component, aerodynamic noise is often distorted in modulation, which consequently affects the condition monitoring. This study is conducted to explore a novel approach to extract low-frequency elements from the aerodynamic noise background, and to improve the efficiency of online monitoring. A framework built on the spline envelope method and improved local mean decomposition has been developed for low-frequency noise extraction, and a case study with real near-field noises generated by a mountain-located wind turbine was employed to validate the proposed approach. Results indicate successful extractions with high resolution and efficiency. Findings of this research are also expected to further support the fault diagnosis and the improvement in condition monitoring of turbine systems.

In this paper, the acoustic emission technique was used to study the signal during the tensile damage of 321 stainless steel for solar thermal power generation. It was found that the peak frequency can effectively distinguish different types of signals during the tensile test. The interference signals generated during the tensile test are effectively resolved by combining the amplitude-peak frequency distribution map and the energy-peak frequency distribution map. The amplitude-time map of the acoustic emission signal is successfully divided into three stages by using peak frequency parameter.