Nowadays, many researches are being carried out to replace the diesel by alternative fuels. Biodiesel and ethanol are strong candidates for this purpose. However, the experimental study of the combustion of biofuels in engines is not an easy task. Due to the large differences between the properties of the new fuels and the conventional diesel, radical changes may be needed in current engines, developed specifically for the fossil fuel. So, the experimental study of ethanol compression ignition (CI) combustion is not simple to be obtained in conventional engines. Therefore, some experimental apparatus, such as a rapid compression machine (RCM), are useful to conduct this kind of study. This paper describes the RCM adaptations made in order to run CI combustion tests using Ethanol-Powered (ED95) and Diesel (S50) for different compression ratios and injection timing. The RCM was equipped with a high pressure common-rail diesel injection system, a piezoelectric sensor, its amplifier and a high speed camera. The idea is to use the results obtained with this system in the future to adapt engines and make correlations with engine tests. The main objective is to develop new technologies to guide the design of new engines and new fuel formulation, quickly reducing the time and costs in the development process. The results show the behavior of combustion with varying the compression ratio and the injection timing. The moment of injection associated with higher compression ratios allows the optimization of the combustion process, increasing thermal efficiency, thus reducing emissions of exhaust gases.
15 August 2015 in Journal of the Brazilian Society of Mechanical Sciences and Engineering
The period between the start of fuel injection into the combustion chamber and the start of combustion it's known as Ignition Delay (ID) or Delay Time. Delay period in the diesel engine exerts a very great influence on both engine design and performance. Functionally, the ID can be divided into two parts: the physical and chemical delay. The physical delay, it is the time between the beginning of injection and the attainment of chemical reaction conditions. During this period, the fuel is atomized, vaporized, mixed with air and raised to self-ignition temperature. Viscosity governs the physical delay of fuel combustion process, for low viscosity fuels, the physical delay tends to be small and vice versa. The chemical delay, during this period reactions start slowly and the accelerate until inflammation or ignitions takes place. Generally, chemical delay is larger than the physical delay. However, it depends on the temperatures thus physical delay becomes longer than the chemical delay. The methods to determine the ignition delay can be broadly classified into two categories: The direct and the indirect methods. Once the rapid compression machine (RCM) already has a piston with a quartz visibility window, the method adopted in the present work was based on the direct method. All tests performed in the RCM had their combustions filmed using a high speed camera. A post-processing of these images enabled us to determine with good precision in which frame the combustion was initiated. Knowing the frame that the combustion starts, the frame rate used during the films and the exact moment when the fuel was injected was possible to evaluate the ignition delay.
22 September 2015 in SAE International Journal of Advances and Current Practices in Mobility
The power generation, used to promote comfort, mobility and others continually grows. The demand for energy grows as much as the number of studies in this field. To solve this growing demand, efforts have been directed towards the development of new energy sources, preferably renewable, and better ways of energy conversion by increasing the processes efficiencies. A good example of this is the gradual change from conventional and highly inefficient vehicles to hybrids or purely electric ones. But even with gradual migration for more efficient energy use, we will continue depending on traditional fuels. Therefore, it is necessary to develop more efficient and less polluting ways to use these sources. Thus, this work aims at studying alternative ways of converting energy contained in fuels used in internal combustion engines. By the use of the combustion mode RCCI, two fluids with different auto-ignition characteristics are introduced into the combustion chamber at different times, with the purpose of burning the fuel with lower power auto-ignition. The amount of each fuel and start of injections (SOI) are parameters that strongly influence the combustion. The results show the parameters for the different techniques of injection of fuels with compression ratios of 16:1 and 20:1.