The standard method for determining the biomass composition, in terms of main lignocellulosic fraction (hemicellulose, cellulose and lignin) contents, is by chemical method; however, it is a slow and expensive methodology, which requires complex techniques and the use of multiple chemical reagents. The main objective of this article is to provide a new efficient, low-cost and fast method for the determination of the main lignocellulosic fraction contents of different types of biomasses from agricultural by-products to softwoods and hardwoods. The method is based on applying deconvolution techniques on the derivative thermogravimetric (DTG) pyrolysis curves obtained by thermogravimetric analysis (TGA) through a kinetic approach based on a pseudocomponent kinetic model (PKM). As a result, the new method (TGA-PKM) provides additional information regarding the ease of carrying out their degradation in comparison with other biomasses. The results obtained show a good agreement between experimental data from analytical procedures and the TGA-PKM method (±7%). This indicates that the TGA-PKM method can be used to have a good estimation of the content of the main lignocellulosic fractions without the need to carry out complex extraction and purification chemical treatments. In addition, the good quality of the fit obtained between the model and experimental DTG curves (R2Adj = 0.99) allows to obtain the characteristic kinetic parameters of each fraction.
Wood flour particleboards (WFP), like other wood-based items, require the addition of fire retardants (FRs) to reduce their high flammability. In this work, a waste lignosulfonate (CaLS) from paper mill is used as a low-cost FR to reduce WFP flammability. CaLS is purified by dialysis and the dialysed lignosulfonate (LD) is used, alone or combined with ammonium polyphosphate (APP), as a FR additive in the preparation of urea-formaldehyde WFP. The fire behaviour of the modified WFPs is studied by cone calorimetry. The use of 15 wt.% LD reduces the peak of heat release rate (HRR) and total smoke production by 25%, also increasing char formation. HRR peak is further reduced up to 40%, if APP is introduced in the formulation. This work discloses a viable and cost-effective strategy for improving the fire retardancy performance of WFP by partial replacement of a commercial FR with a fully renewable additive, isolated through a green and cost-effective process.
The bioeconomy can be integral to transforming the current economic system into one with reduced environmental and social impacts of material consumption. This work describes a bio-based multi-layer panel that is based on residual coniferous bark. To ensure that the presented bio-based panel positively contributes to environmental protection while remaining competitive with conventional products and meeting high social standards, the development of the panel is accompanied by a life cycle sustainability assessment. This study performs a comparative LCA and LCC of the developed panel to conventional benchmark panels, as well as a qualitative social life cycle assessment. While the panel performs only economically marginally weaker than the benchmarks, the results are more heterogeneous for the environmental dimension with benefits of the bio-based panel in categories such as climate change, acidification, and ozone formation and detriments in categories including eutrophication. The S-LCA analysis shows that all of the involved companies apply social principles in direct proximity; however, social responsibility along the supply chain could be further promoted. All results need to be viewed with the caveat that the manufacturing processes for the new panel have been implemented, to date, on a pilot scale and further improvements need to be achieved in terms of upscaling and optimisation cycles.