An experimental investigation was undertaken to ascertain the potential of using Helmholtz resonance for volume determination and the factors that may influence accuracy. The uses for a rapid non-interference volume measurement system range from agricultural produce and mineral sampling through to liquid fill measurements. By weighing the sample the density can also measured indirectly.
The use of thermocouples in many present-day applications can often occur with little consideration as to the inherited historical burden of the reference functions the thermocouples must meet. For base-metal thermocouples, the reference functions are specified by equations relating temperature to electro-motive-force and not by alloy composition. Most of the common thermocouples contain at least one alloyed thermoelement, the bulk of which are now known to be inherently unstable above 200 °C. As manufacturing technologies change, along with the material feedstock from which thermocouples are made, modern thermocouples can frequently give measurements that deviate significantly from the ASTM and IEC standards. This study first reviews the development of the thermocouple alloys and historical conditions under which the reference functions were derived and contrasts this with modern thermocouple alloys and new testing methods. From this comparison, it is shown that users of modern base-metal thermocouples need to be extremely cautious when anticipating likely behaviour, with even short exposures to modest temperatures revealing a myriad of manufacturer-dependent instabilities. Minor variations in composition are shown to strongly influence reversible crystallographic ordering effects in addition to passivation behaviour at high temperatures, in some instances leading to catastrophic failure. It is also shown that the initial anneal state given by the manufacturer has a significant effect on the stability and hence, drift rate, with inadequate anneal leading to unnecessarily large drift rates at less than 200 °C. Lastly, this review looks at recent attempts to develop more-stable thermocouples, based on state-of-the-art techniques able to identify specific causes of instability in many of the historic thermocouple alloys and demonstrates how these new thermocouples might better serve the end user’s needs.
12 December 2014 in International Journal of Thermophysics