This study paves the way on reducing smoke emission and NOx emissions of research diesel engine by detailing the effect of water addition in biodiesel. Fuel samples were prepared with different concentrations of water in orange peel oil biodiesel (94% waste orange peel oil biodiesel + 4% water + 2% Span 80 (WOPOBDE1) and 90% waste orange peel oil biodiesel + 8% water + 2% Span 80 (WOPOBDE2). Span 80 was employed as a nonionic surfactant, which emulsifies water in biodiesel. Experimental results revealed that the nitrogen oxides and smoke emission of orange peel oil biodiesel emulsion were reduced by 11%–19% and 3%–21%, respectively, compared to that of neat orange peel oil biodiesel (WOPOBD). In addition, the introduction of orange peel oil–water emulsions in the diesel engine considerably reduced the emissions of unburned hydrocarbons and carbon monoxide. The overall hydrocarbon emission of WOPOBDE2 was 12.2% lower than that of WOPOBD and 16.3% lower than that of diesel. The overall CO emission of WOPOBDE2 was 17% lower than that of base fuel (WOPOBD) and 21.8% lower than that of diesel. Experimental results revealed that modified fuel had higher brake thermal efficiency and lower brake specific fuel consumption than that of base fuel at all engine brake power levels.
Synthetic fiber-reinforced composites are difficult to be disposed of after their intended use due to their non-biodegradable nature. Natural plant fibers, which are renewable and fully biodegradable, are, therefore, ideal alternatives that can replace synthetic fibers. In this research paper, the application of biodegradable Coccinia grandis fiber-reinforced epoxy bio composite is investigated. The randomly oriented Coccinia grandis fiber-reinforced bio composites were prepared by compression molding with 10%, 20%, 30%, 40%, and 50% fiber weight. Tensile, flexural, and impact tests were used to determine the composite’s mechanical properties, and Field Emission Scanning Electron Microscopy (FESEM) was used to understand the interfacial bonding. The obtained results revealed that 40% fiber weight could produce Coccinia grandis fiber-reinforced bio composite with the highest tensile strength, impact strength, and interfacial adhesion among all the prepared composites, whereas 50% fiber weight could make the bio composite with the highest flexural strength. The results show that the Coccinia grandis fiber-reinforced bio composites seem to have potential applications in automobile, construction, interiors, etc.
The increasing demand for natural fiber-reinforced composites has opened up the market for inexpensive, lightweight, bio-renewable, and environment-friendly plant fibers. The chemical treatments on fiber lead to the reduction of lignin and hemicellulose contents which helps in better adhesion with the matrix. The objective of this work is to do various chemical treatments on Cissus quadrangularis Stem Fiber (CQSF) and perform its characterization. The natural fibers are first extracted from the Cissus quadrangularis stem using the retting process. The fibers are then chemically treated with magnesium carbonate (MgCO3), sodium hydroxide (NaOH), sodium carbonate (Na2CO3), sodium bicarbonate (NaHCO3), and calcium hydroxide (Ca(OH)2). The characterization of single fibers is investigated by single-fiber tensile test, chemical composition, thermogravimetric analysis, and field emission scanning electron microscope. Characterization results show that the MgCO3-treated CQSF has improved mechanical and thermal properties. Thus, MgCO3-treated CQSF is suggested for biocomposite preparation due to its promising mechanical properties and thermal properties.