Potentially toxic metals pollution in the Straits of Malacca warrants the development of rapid, simple and sensitive assays. Enzyme-based assays are excellent preliminary screening tools with near real-time potential. The heavy-metal assay based on the protease ficin was optimized for mercury detection using response surface methodology. The inhibitive assay is based on ficin action on the substrate casein and residual casein is determined using the Coomassie dye-binding assay. Toxic metals strongly inhibit this hydrolysis. A central composite design (CCD) was utilized to optimize the detection of toxic metals. The results show a marked improvement for the concentration causing 50% inhibition (IC50) for mercury, silver and copper. Compared to one-factor-at-a-time (OFAT) optimization, RSM gave an improvement of IC50 (mg/L) from 0.060 (95% CI, 0.030–0.080) to 0.017 (95% CI, 0.016–0.019), from 0.098 (95% CI, 0.077–0.127) to 0.028 (95% CI, 0.022–0.037) and from 0.040 (95% CI, 0.035–0.045) to 0.023 (95% CI, 0.020–0.027), for mercury, silver and copper, respectively. A near-real time monitoring of mercury concentration in the Straits of Malacca at one location in Port Klang was carried out over a 4 h interval for a total of 24 h and validated by instrumental analysis, with the result revealing an absence of mercury pollution in the sampling site.
31 December 2023 in Journal of Environmental Bioremediation and Toxicology
Because they catalyze reactions without changing themselves, enzymes are like catalysts in nature. Any enzyme that hydrolyzes the peptide bonds that connect amino acids in a polypeptide chain is considered a protease and initiates protein catabolism. They are useful for both synthetic and degradative purposes. Enzymes are most often found in microbes, and they are more active and stable than enzymes found in plants or animals. Because they multiply quickly, take up little room, and are amenable to genetic manipulation, microbes are a great choice for producing enzymes because we can easily change their features to suit our needs. Different proteases are known as endopeptidases or exopeptidases, depending on whether they work at or away from the termini. On the other hand, proteases are categorized as acidic, alkaline, or neutral depending on their ideal pH. Here we had a look at the many biotechnological uses of alkaline proteases, including in the food, tannery, brewery, silver recovery, and other industrial sectors as well as in medicine, ecology, and sustainability initiatives. The purification processes as well as the optimum condition of the protease was also discussed, in order to provide a comprehensive review about applications of alkaline proteases for sustainable development.
31 December 2022 in Bioremediation Science and Technology Research
Mycotoxins are harmful secondary metabolites generated by a variety of fungi, and they may be found in a vast array of food and feed commodities and processed meats from animals fed infected meal. Numerous mycotoxins are extremely resistant and survive food processing, entering the food chain and posing a concern to human health. The "optical waveguide lightmode spectroscopy" (OWLS) method was used to detect aflatoxin B1 in plant sample matrices. The calibration curve for the detection of aflatoxin B1 utilizing "optical waveguide lightmode spectroscopy" (OWLS) displayed a sigmoidal shape; hence, the 5-PL or 4-PL model should be used to fit the data rather than a linear model. Using error function analysis with functions such as AICc, HQC, BIC, RMSE, adjR2, Bias Factor, and Accuracy Factor, the 5-PL and 4-Pl models are distinguished inconsistently. The overlapping confidence intervals of the LogEC50 values suggested that the two techniques did not differ much, and the 4-PL model was selected due to its smaller number of parameters. The Limits of Detection for aflatoxin B1 value based on the 4-PL equation was 8.787 ng/mL with the 95% confidence interval from 5.728 to 13.100. In this study, the use of the 4-PL model was successful and was able to represent the entire date curve, not only the linear section. The linear component is crucial as a handy and swift approach for assessing the sensitivity of a developed biosensor technology and is often a more beneficial method for field applications when a quick and straightforward evaluation is required.
31 December 2022 in Journal of Biochemistry, Microbiology and Biotechnology
This study was conducted to assess the health risk of heavy metals from some fruits and vegetables sold in the Dutse Ultra-modern market, Jigawa State. Two fruits (watermelon and orange) and two vegetables (okra and spinach) were selected randomly from two vendors for two consecutive periods within one week. The samples were transported to the laboratory for acid digestion. Atomic Absorption Spectrophotometer (AAS) was used for the determination of heavy metal (Cd, Pb, Zn, Fe, Mg, Cr and Ni) concentration in the various samples. Bioaccumulation factor, pollution index, hazard quotient and hazard index were calculated and compared with WHO standard. Results obtained in the present study revealed that Cd levels in the samples were significantly higher as compared with the control value (0.2 mg/mL). Pb, Fe, Cr and Ni evaluated were insignificant as compared with their control (2 mg/mL, 1 mg/mL, 1.3 mg/mL and 10 mg/mL, respectively). The results revealed only Cr (1.5) and Ni (1.7) have significantly high bioaccumulation factors while all other heavy metals show relatively low bioaccumulation. The pollution index of heavy metals in the samples of fruits and vegetables evaluated shows a relatively low pollution index, values obtained vary from 0.11 in Pb to 0.9 in Ni. While hazard quotients and hazard index were insignificant. The study concludes that okra, spinach, orange and watermelon in the Dutse ultra-modern market in Jigawa state despite their proximity to the mechanic village and a lot of activities occurring may not cause a serious health threat to human consumption. The study recommends further studies on other fruits and vegetables not selected for this study.
Heavy metals pollution in the Straits of Malacca warrants the development of rapid, simple and sensitive assays. Enzyme-based assays are excellent preliminary screening tool with near real-time potential. The heavy-metal assay based on the protease ficin was optimized for mercury detection using Response Surface Methodology. The inhibitive assay is based on ficin action on the substrate casein and residual casein is determined using the Coomassie dye-binding assay. Heavy metals strongly inhibit the hydrolysis. A Central Composite Design (CCD) was utilized to optimize detection. The results show a marked improvement for the concentration causing 50% inhibition (IC50) for mercury, silver and copper. Compared to One-factor-at-a-time (OFAT) optimization, RSM gave an improvement of IC50 from 0.060 (95% CI, 0.0300.080) to 0.017 (95% CI, 0.0160.019), from 0.098 (95% CI, 0.0770.127) to 0.028 (95% CI, 0.0220.037) and from 0.040 (95% CI, 0.035.045) to 0.023 (95% CI, 0.0200.027), for mercury, silver and copper, respectively. A near real-time monitoring of mercury concentration in the Straits of Malacca at one location in Port Klang was carried out over a 4-h interval for a total of 24 h and validated by instrumental analysis with the result revealing an absence of mercury pollution in the sampling site.
25 December 2024 in Journal of Environmental Bioremediation and Toxicology
Agricultural areas in Nigeria depend upon unpolluted water sources and hence need continuous monitoring. River Challawa is among the water sources for domestic and agricultural purposes. It is located in an industrialized area of Kano, Nigeria. A cucumber protease-based assay for the detection of lead metal has been developed to determine the efficiency of the monitoring method. Cucumber protease is assayed by using casein as a substrate with Coomassie brilliant blue to track the complete hydrolysis of the substrate. In the presence of inhibitors such as metal ions, casein is not hydrolyzed to completion, and the solution is dark blue. The cucumber protease assay was optimized using One-Factor-at-a-Time (OFAT) and Response Surface Methodology (RSM). The RSM-optimized method demonstrated superior sensitivity, reducing the IC50 value for lead detection from 0.078 mg/L (OFAT) to 0.028 mg/L. The findings show a marked improvement in concentration, causing 50% inhibition ( IC50) for lead metal in River Challawa. The results of the comparison between one factor at a time (OFAT) optimization and RSM provide an improvement of IC50 for lead ion from 0.078 (95% CI,0.057 to 0.27) to 0.028 (95% CI, 0.022 to 0.037). The LOD for lead Pb2+ is 0.015 and 0.003 for OFAT and RSM, respectively. The results of this study indicate that cucumber-protease assay has the potential efficiency of being used in the determination of lead metal in water samples.