This study undertook an investigation of an important problem, so far completely overlooked in the palynological literature – to determine the optimal sample size for pollen grain morphological studies. In other words, we investigated the number of pollen grains which should be measured in order to obtain a representative mean value of a given quantitative feature which, in consequence, would make it possible to more accurately describe the pollen of a given taxon. Investigations were conducted on a sample comprising 3850 Rosa canina L. pollen grains on the basis of the length of the polar axis (P), the equatorial diameter (E) and the P/E ratio, at the flower, specimen and population levels. The size of the pollen samples analysed reflected common sample numbers employed in previous pollen morphology studies, namely from five through 10, 20, 30, 50, 100 up to 200 pollen grains. The statistical analyses performed revealed a relatively low variability in pollen grain biometric features at the levels of flower, specimen and population. At the lowest level of variability analysed, it is sufficient to take measurements of several grains to obtain values satisfactorily representing the variability within the flower level. At the level of a specimen or population, the number of grains necessary to secure representative mean values should range from 15 to 20. However, when the research objective is not only information regarding mean values of pollen grain biometric features but also the analysis of their variability (min–max), then the sample size should include approximately 30 grains. The results obtained, apart from their significance in taxonomic studies, also possess important practical significance; measurements of pollen grain biometric features are very labour-intensive and costly and, sometimes, because of difficulties in obtaining satisfactory quantities of plant material (e.g. herbarium specimens, rare species, paleopalynological collections), also very sparse.

Next to global warming, excessive deposition of nitrogen has an alarming environmental impact on forest ecology, especially within dioecious species. Resource availability affects seed quality and can affect the distribution of plant species. Lower seed productivity can also be a result of limited pollen availability or lower pollen quality. A few studies have assessed the effect of nutrient availability on the quantity and quality of pollen grains produced. Therefore, rooted shoots of dioecious, male Juniperus communis L. grown in different nutritional conditions were used to assess the impact on productivity and quality attributes of produced pollen grains (pollen volume, morphology, germination, and chemical composition). The results indicated that nutrient availability impacts pollen grain development. Male plants growing in nutrient-rich environments appear to compensate for the lower quality of produced pollen grains by producing a higher number of male cones and thus a greater quantity of pollen. In contrast, the opposite was observed in plants growing in nutrient-poor environments. The availability of nitrogen and other nutrients will probably continue to impact soils in the foreseeable future due to anthropogenic activity and can be one of the drivers that can impact the reproduction and distribution of plants.

The aim of this study is verification of the taxonomic usefulness of the pollen grain features studied, based on pollen morphology of 32 wild species from all 4 subgenera and all 10 sections of the genus Rosa, mainly for delimitation of subgenera, sections, and species. The measurements and observations were carried out with both light microscopy and scanning electron microscopy. Only correctly formed pollen grains (30 per specimen) were measured, and 960 pollen grains were examined in total. They were analyzed for 14 quantitative features of pollen grains and exine sculpturing and the following qualitative ones: outline, shape, and operculum structure. Our study revealed that the diagnostic features of pollen grains studied were: exine sculpture, length of polar axis, and pollen shape (P/E ratio). On the basis of the above characters, five species were isolated and the remaining ones were included in several groups isolated on the basis of exine sculpture types. The following three exine sculpture types occurred in the species studied: granular-verrucate (in R. stellata), striate-psilate (in R. multibracteata and R. multiflora), and striate (the remaining species). R. banksiae is characterized by small pollen grains, while R. setigera has strongly elongated pollen with P/E ratio >1.5. Exine sculpture features considered to be diagnostic should be treated as auxiliary because they fail to differentiate individual species, although they can be helpful in distinguishing groups of species of similar exine sculpture. The arrangement of the species examined on a dendrogram only slightly corroborates division of the Rosa genus into subgenera and sections currently adopted in taxonomy (Rehder 1940). An interesting result was reported for the species studied from the Caninae (R. agrestis, R. canina, R. dumalis, R. jundzillii, and R. rubiginosa) section which, despite hybrid nature, with the exception of R. villosa, grouped in the same, most separated group of species.

The Erica genus has as yet not been investigated satisfactorily in terms of palynology. Its complicated taxonomic system, large number of species, as well as its extensive but disrupted range of occurrence, all contribute to the fact that few researchers have undertaken investigations of this species. It was assumed that the research results would be representative thanks to a complex comparative analysis of all diagnostical, morphological pollen features performed on properly selected plant material, representing the most important distinguished intrageneric taxons at the present time (45 species from all five subgenera and 22 sections), both discriminated pollen dispersal units (tetrads and monads) as well as the main centres of genus occurrence and diversification (species from Europe, the Republic of South Africa (RSA) and Madagascar). The study revealed that the diagnostic features of the pollen grains studied were: pollen dispersal unit, exine ornamentation, P/E ratio, tetrad diameter (D) and length of polar axis (P). On the basis of these traits, 14 Erica species (six creating monads and eight—tetrads) were distinguished which, in the case of pollen features, constitutes a significant number. Other heaths created small groups, usually containing two or three species, but up to seven species. The present study, based on the highest number of Erica species (45) analysed so far, corroborated the view that an examination of palynological features may assist in clarifying classification systems for the large and taxonomically very difficult Erica genus, in particular, at the level of the subgenus and section, but also at species level. The results obtained indicate the need to continue palynological investigations on the Erica genus.

Pollen morphology of three parental Quercus species (Q. robur L., Q. petraea (Matt) Liebl, Q. pubescens Willd.) and two spontaneous hybrids of these species (Q. ×calvescens Vuk. = Q. petraea × Q. pubescens and Q. ×rosacea Bechst. = Q. robur × Q. petraea) was investigated in this study. The pollen originated from 18 natural oak sites and 67 individuals (oak trees). Each individual was represented by 30 pollen grains. In total, 2010 pollen grains were measured. They were analysed for nine quantitative and four qualitative features. Pollen size and shape were important features to diagnosing Quercus parental species and hybrids. On the basis of exine ornamentation, it was possible to identify only Q. pubescens, while the remaining species and hybrids did not differ significantly with respect to this feature. The determination of the diagnostic value of endoaperture features requires further palynological studies. On the basis of pollen size and shape Q. robur × Q. petraea was clearly separated. Grouping of 67 oak trees on the basis of pollen grain features has shown that individuals from different as well as same taxa occurred in the same groups. Likewise, with respect to natural sites, oak trees originating from the same places as well as from geographically distant ones, grouped together. Pollen morphological features allow to distinguish a part of the studied Quercus taxa. Therefore, it can be used as an auxiliary feature in the taxonomy.