Abdel-Sattar Gadallah

Dr. Abdel-Sattar Gadallah

orcid

Research Focus & Metrics

Academic Career Length

19Years (2008-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2013 in Advances in Condensed Matter Physics
Verified
Journal Article
Open access
PDF file
AGAbdel-Sattar Gadallah
Abdel-Sattar Gadallah
MEM. M. El-Nahass
M. M. El-Nahass
We report manufacturing and characterization of low cost ZnO thin films grown on glass substrates by sol-gel spin coating method. For structural properties, X-ray diffraction measurements have been utilized for evaluating the dominant orientation of the thin films. For optical properties, reflectance and transmittance spectrophotometric measurements have been done in the spectral range from 350 nm to 2000 nm. The transmittance of the prepared thin films is 92.4% and 88.4%. Determination of the optical constants such as refractive index, absorption coefficient, and dielectric constant in this wavelength range has been evaluated. Further, normal dispersion of the refractive index has been analyzed in terms of single oscillator model of free carrier absorption to estimate the dispersion and oscillation energy. The lattice dielectric constant and the ratio of free carrier concentration to free carrier effective mass have been determined. Moreover, photoluminescence measurements of the thin films in the spectral range from 350 nm to 900 nm have been presented. Electrical measurements for resistivity evaluation of the films have been done. An analysis in terms of order-disorder of the material has been presented to provide more consistency in the results.

29 April 2013 in Applied Physics Letters
Verified
Journal Article
Closed access
AGAbdel-Sattar Gadallah
Abdel-Sattar Gadallah
KNK. Nomenyo
K. Nomenyo
CCC. Couteau
C. Couteau
DRD. J. Rogers
D. J. Rogers
GLGilles Lerondel
Gilles Lerondel
Stimulated surface- and edge-emissions were investigated for ZnO thin films grown epitaxially by pulsed laser deposition. The lasing threshold was 0.32 MW/cm2 for surface pumping and 0.5 MW/cm2 for edge pumping, which is significantly lower than thresholds observed previously. A modified variable stripe length method was used to measure the gain, which was 1369 cm−1 for the N-band emission. Losses were measured using the shifting excitation spot method and values of 6.2 cm−1 and 6.3 cm−1 were found for the N-band and P-band, respectively. The measured gain and loss were the highest and lowest (respectively) ever reported for ZnO films.

27 May 2011 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
AGAbdel-Sattar Gadallah
Abdel-Sattar Gadallah
RMRainer Michalzik
Rainer Michalzik
We report high-power single-higher-order transverse mode emission of a large-area oxide-confined rectangular-shaped vertical-cavity surface-emitting laser (VCSEL) with a multispot shallow surface relief. Both a record-high output power of 12 mW and a record-low differential series resistance of 18 Ω are achieved. Stable single-higher-order transverse mode emission with a sidemode suppression ratio (SMSR) exceeding 35 dB is maintained up to thermal rollover. Single-polarization lasing along the major axis is achieved with 27.5-dB spectral orthogonal polarization suppression ratio at thermal rollover. Measurements of near- and far-field intensity profiles of the higher-order mode are also presented.

1 November 2013 in Optics & Laser Technology
Verified
Journal Article
Closed access
AGAlaa E. Giba
Alaa E. Giba
AGAbdel-Sattar Gadallah
Abdel-Sattar Gadallah
MMMona B. Mohamed
Mona B. Mohamed
IAI.M. Azzouz
I.M. Azzouz

25 April 2008
Verified
Conference Paper
Closed access
PDF file
AGAbdel-Sattar Gadallah
Abdel-Sattar Gadallah
AKAndrea Kroner
Andrea Kroner
IKIhab Kardosh
Ihab Kardosh
FRFernando Rinaldi
Fernando Rinaldi
RMRainer Michalzik
Rainer Michalzik
We report on the theoretical analysis and fabrication of a novel type of vertical-cavity surface-emitting laser (VCSEL) that provides selection of a certain higher-order transverse mode. This selection is based on a spatial variation of the threshold gain by adding an antiphase layer with an etched relief structure. The field intensity profile emitted from this laser is calculated numerically as well as with an analytical approach. The main factors that control the selected mode such as the threshold gain, the confinement factor, and the phase parameter are calculated as a function of the active aperture, aiming to achieve single higher-order transverse mode emission. For a given aspect ratio of a rectangular oxide aperture, the threshold gain difference between the selected and neighboring modes is maximized via the relief diameter and the size of the aperture. The fabrication process involves selective etching of the antiphase layer, passivation of the relief, oxidation of an AlAs layer to the desired aperture after reaching this layer using wet-chemical etching. N- and p-metalization processes are applied, followed by polyimide passivation. Finally, bondpad metalization is carried out for electrical contacting. Mode selection is successfully achieved. Attractive applications for such devices are found in optical manipulation of micro-particles such as sorting and separation.© (2008) COPYRIGHT SPIE--The International Society for Optical Engineering. Downloading of the abstract is permitted for personal use only.

27 March 2017 in Advances in Materials Science and Engineering
Verified
Journal Article
Open access
PDF file
ARAhmed Razeen
Ahmed Razeen
AGAbdel-Sattar Gadallah
Abdel-Sattar Gadallah
MEM. M. El-Nahass
M. M. El-Nahass
Low cost ultraviolet stimulated emission has been generated using optical excitation of ZnO thin films deposited by sol-gel spin coating on n+As-doped100Si-substrate. The number of deposited layers and the heat treatment have been investigated to obtain a film that can generate stimulated emission under optical excitation. The optimum condition for preparation of the film has been presented. X-ray diffraction and scanning electron microscope have been used for structural and morphological investigations. Input-output intensity dependence and spectral width, peak emission wavelength, and the quantum efficiency versus the pump intensity have been presented. A quantum efficiency of about 24.2% has been reported, a power exponent higher than 8 has been obtained in input-output intensity dependence, and a threshold of about 23 Mw/cm2has been evaluated for the samples. The mechanism by which stimulated emission occurs has been discussed. The results show that sol-gel spin coating is a promising method for generating ultraviolet stimulated emission from ZnO thin films.