In order to successfully integrate biomass pyrolysis oils as starting materials for conventional oil refineries, upgrading of the pyrolysis oils is needed to achieve desired properties, something which can be performed either as part of the pyrolysis process and/or by separate catalytic treatment of the pyrolysis intermediate oil products. In this study, the quality of stem wood-derived pyrolysis oil was improved via ex situ catalytic hydropyrolysis in a bench-scale pyrolyzer (stage 1), followed by catalytic hydro-coprocessing with fossil co-feed in a laboratory-scale high pressure autoclave (stage 2). The effect of pyrolysis upgrading conditions was investigated based on the quality of intermediate products and their suitability for hydro-coprocessing. HZSM-5 and Pt/TiO2 catalysts (400 °C, atmospheric pressure) were employed for ex situ pyrolysis, and the NiMoS/Al2O3 catalyst (330 °C, 100 bar H2 initial pressure) was used for hydro-coprocessing of the pyrolysis oil. The application of HZSM-5 in the pyrolysis of stem wood under a N2 atmosphere decreased the formation of acids, ketones, aldehydes, and furans and increased the production of aromatic hydrocarbons and phenolics (guaiacols and phenols). Replacing HZSM-5 with Pt/TiO2 and N2 with H2 resulted in complete conversion of guaiacols and significant production of phenols, with further indications of increased stability and reduced coking tendencies.
In this work, predictions from a reacting Computational Fluid Dynamics (CFD) model of a gasification reactor are compared to experimentally obtained data from an industrial pressurized black liquor gasification plant. The data consists of gas samples taken from the hot part of the gasification reactor using a water cooled sampling probe. During the considered experimental campaign, the oxygen-to-black liquor equivalence ratio (λ) was varied in three increments, which resulted in a change in reactor temperature and gas composition. The presented numerical study consists of CFD and thermodynamic equilibrium calculations in the considered λ-range using boundary conditions obtained from the experimental campaign. Specifically, the influence of methane concentration on the gas composition is evaluated using both CFD and thermodynamic equilibrium. The results show that the main gas components (H2, CO, CO2) can be predicted within a relative error of 5% using CFD if the modeled release of H2S and CH4 are specified a priori. In addition, the calculations also show that the methane concentration has large influence on the reactor outlet temperature and final carbon conversion.